Abstract:It is commonly known that riblets with sharper tip generally have better turbulent drag reduction capacity, which, however, poses great challenges for manufacturing and makes the riblets vulnerable to tip erosion. In this study, we show that a scalloped riblet which is not as sharp in the tip as corresponding triangular riblet with same height-width ratio, nevertheless has a larger protrusion height, a quantity solely depending on the riblet shape and calculated through a boundary element algorithm in this study, and thus a higher projected drag reduction rate. In addition, it is found that, when subjected to tip rounding, this scalloped riblet performs better in terms of protrusion height than corresponding parabolic riblet, which indicates stronger resilience to riblet tip erosion. With the class of scalloped riblets, designed by smoothly connecting two third-order polynomials and thus the tip sharpness and valley curvature can be well defined, it is revealed that two mechanisms, one for the valley curvature at the viscous limit and one for the tip sharpness at infinite deep limit, determine the protrusion height, and thus the projected drag reduction capacity. Direct numerical simulations are then carried out to investigate controlled boundary layer transition with the scalloped riblet of width s(+) = 20 and s(+) = 60. A 7.8% drag reduction in the turbulent region is found for the smaller riblet with a preferable transition delay, while for the larger riblet transition is promoted and drag is increased in the turbulent region. It is also found that the area fraction of high drag region around the riblet tips is basically the same for the two cases. Surprisingly, even higher drag is found around the tip region for the smaller drag-reducing riblets. On the other hand, a much smaller drag coefficient is found in the valley of the smaller riblet, which results in the reduction of turbulent drag. It is thus inferred that the issue of sharp riblet tip, that hard to manufacture and deteriorate substantially when subjected to tip erosion, could be mitigated by optimization of the riblet geometry.

Study of Riblet Drag Reduction for an Infinite Span Wing with Different Sweep Angles

Study on Riblet Drag Reduction Considering the Effect of Sweep Angle

Numerical study of an airfoil with riblets installed based on large eddy simulation

Numerical Analysis of Turbulence Characteristics in a Flat-Plate Flow with Riblets Control

Numerical Study of Effect of Sawtooth Riblets on Low-Reynolds-Number Airfoil Flow Characteristic and Aerodynamic Performance

Drag reduction using riblets downstream of a high Reynolds number inclined forward step flow

Numerical analysis of drag reduction with longitudinal riblets

The flow structure on drag-reduced riblet surfaces

Experimental investigation of yaw-angle effects on drag reduction rate for trapezoidal riblets

Numerical Investigation of V-shaped Riblets and an Improved Model of Riblet Effects

Effect of Different Flow Directions on Drag over Riblet

Laminar vortex dynamics around forward-swept wings

The Characteristic and Mechanism of Three Different Shapes of Riblets on Drag Reduction

Riblet Surface Drag Reduction on Subsonic Aircraft

Aerodynamic characterization of low-aspect-ratio swept wings at $Re=400$

Drag reduction by riblets

Characteristics of flow over thin triangular riblet surface

On the drag reduction of an inclined wing via microstructures with the immersed boundary-lattice Boltzmann flux solver

Numerical investigation of drag reduction effects on a track bicycle fork using wings with a wavy leading edge

On the Tip Sharpness of Riblets for Turbulent Drag Reduction

Drag reduction by a superhydrophobic surface with longitudinal grooves: the effects of the rib surface curvature