Fe/Li Co-doped CuO: enhanced photosensing and conductivity correlated with structural modifications

Prashant Kumar Mishra,Rachit Dobhal,Somaditya Sen
DOI: https://doi.org/10.1007/s10854-024-13463-x
2024-09-11
Journal of Materials Science Materials in Electronics
Abstract:The photocatalytic and electronic properties of sol–gel-prepared divalent Fe 3+ and Li + co-doped monoclinic (c2/c) Cu 0.945 Fe 0.055-x Li x O powders were investigated. O-ions are in excess in Fe-rich samples, whereas O-vacancies (Vo) are prevalent in Li-rich samples due to the valence state differences between Fe 3+ and Li + ions. The bandgap remained largely unaffected, but lattice disorder increased with higher Li content. The electrical conductivity ( σ ) increased with increasing Li content. While the p -type nature decreased with increasing Li content, the electron mobility decreased with increasing Li content. The photocatalytic decomposition of harmful methylene blue (MB) dye was maximum for Cu 0.945 Fe 0.0275 Li 0.0275 O. For both Cu 0.945 Fe 0.055 O and Cu 0.945 Li 0.055 O, the degradation was lesser due to other physical processes, e.g., changes in the photocurrent. Light detection was faster in Fe-rich samples compared to pure and Li-rich samples. An attempt was made to form a heterojunction of ZnO/Cu 0.945 Fe 0.014 Li 0.041 O that exhibited significantly faster response times than their bulk counterparts for both pure and Li-rich samples. These findings highlight the potential of Cu 0.945 Fe 0.055-x Li x O samples and heterojunction configurations for enhanced photocatalytic and sensing applications.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied
What problem does this paper attempt to address?