Abstract:The paper presents an analysis of the effective use of a mixture of steel sludge (S1) and slag (S2) from the converter process of steel production for the production of cement mortars. Metallurgical waste used in the research, which is currently deposited in waste landfills and heaps near plants, posing a threat to groundwater (possibility of leaching metal ions present in the waste), was used as a substitute for natural sand in the range of 0-20% by weight of cement (each). The obtained test results and their numerical analysis made it possible to determine the conditions for replacing part of the sand in cement mortars with a mixture of sludge and slag from a basic oxygen furnace (BOF) and to determine the effects of such modification. For the numerical analysis, a full quadratic Response Surface Model (RSM) was utilized for two controlled factors. This model was subsequently optimized through backward stepwise regression, ensuring the inclusion of only statistically significant components and verifying the consistency of residual distribution with the normal distribution (tested via Ryan-Joiner's test, p > 0.1). The designated material models are helpful in designing ecological cement mortars using difficult-to-recycle waste (i.e., sludge and converter slag), which is important for a circular economy. Mortars modified with a mixture of metallurgical waste (up to 20% each) are characterized by a slightly lower consistency, compressive and flexural strength, and water absorption. However, they show a lower decrease in mechanical strength after the freezing-thawing process (frost resistance) compared to control mortars. Mortars modified with metallurgical waste do not have a negative impact on the environment in terms of leaching heavy metal ions. The use of a mixture of sludge and steel slag in the amount of 40% (slag/sludge in a 20/20 ratio) allows you to save 200 kg of sand when producing 1 m3 of cement mortar (cost reduction by approx. EUR 5.1/Mg) and will also reduce the costs of the environmental fee for depositing waste.

Influence of replacing Portland cement with three different concrete sludge wastes

Use of sludge from water treatment decanter in cement composites

Mechanical and Durability Properties of Mortars Incorporating Red Mud, Ground Granulated Blast Furnace Slag, and Electric Arc Furnace Dust

Effect of Wet Grinding Concrete Slurry Waste on Hydration and Hardening Properties of Cement: Micro-Nano-Scale Modification

Incorporating Wastewater Sludge as a Cement Alternative in Repair Mortar: An Experimental Study of Material Properties

Research on Sustainable Development of Fine-Grained Material Cement Slurry

Use of Slag from the Combustion of Solid Municipal Waste as A Partial Replacement of Cement in Mortar and Concrete

Behaviour and Properties of Eco-Cement Pastes Elaborated with Recycled Concrete Powder from Construction and Demolition Wastes

Use of concrete fine fraction waste as a replacement of Portland cement

Effect of Sandy Soil Partial Replacement by Construction Waste on Mechanical Behavior and Microstructure of Cemented Mixtures

Assessment of Pb-slag, MSWI bottom ash and boiler and fly ash for using as a fine aggregate in cement mortar

Strength and Durability Characteristics of Cement Composites with Recycled Water and Blast Furnace Slag Aggregate

Performance of concrete with the incorporation of waste from the process of stoning and polishing of glass as partial replacement of cement

Up to 100% Replacement of Natural Materials from Residues: Recycling Blast Furnace Slag and Fly Ash as Self-Leveling Cementitious Building Materials

The Multifaceted Comparison of Effects of Immobilisation of Waste Imperial Smelting Furnace (ISF) Slag in Calcium Sulfoaluminates (CSA) and a Geopolymer Binder

The Application of Converter Sludge and Slag to Produce Ecological Cement Mortars

Research on Cement Slurry Using Silica Fume Instead of Fly Ash

Effective reutilization of textile sludge from common effluent treatment plant with mineral admixture as a partial replacement for cement in mortar mixes

Influence of Cement Replacement with Sewage Sludge Ash (SSA) on the Heat of Hydration of Cement Mortar

Influence of industrial waste and mineral admixtures on durability and sustainability of high-performance concrete

Feasibility of stone slurry powder and admixtures in cement mortar