Abstract:We focus on the parameter identification of doubly fed induction generator （DFIG} based wind turbine generator （WTG）. Firstly, the trajectory sensitivity analysis is used to make judgments about the identifiability of parameters. If the phases of sensitivity curves are not the same or reverse, the parameters are uniquely identifiable. By this theory, we find that the stator reactance and rotor reactance cannot be simultaneously identified, but the other parameters are uniquely identifiable. Secondly, the difficulty of identification which means the possibility of obtaining the accurate values o{ the parameters from the measurement data is analyzed. A parameter is easy to be identified if the sensitivities of both time-domain and frequency-domain are high. A parameter which has a high value only in the low frequency area of the frequency-domain sensitivity curve is relatively easy to be identified. It is found that the stator reactance, rotor reactance, and exciting reactance are easy to be identified; the stator resistance and rotor resistance are relatively easy to he identified; the inertial constant is difficult to be identified. According to the analysis of identifiability and the difficulty of identification, four key parameters including the stator resistance, stator reactance, exciting reactance, and rotor resistance are decided to be identified. Then, an ant colony optimization algorithm based identification method is designed. Finally, the correctness of the analysis and the efficiency of the identification method are validated by the simulation results obtained in Matlab/Simulink environment.

Parameter Identification of the Series Inductance in DAB Converters

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Analysis on the Identification of Doubly Fed Induction Generator

Modeling and Parameter Identification of DC/DC Converters in Both CCM and DCM Mode

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Model Predictive Control with a Novel Parameter Identification Scheme for Dual-Active-Bridge Converters

Research on Parameter Identification of Buck Circuit

Parameter Identification of Power Electronic Circuits Based on Hybrid Model

A Parameter Design Method of CLLC Resonant Converter Based On Time-Domain Model

Parameter Identification of Induction Motors for Railway Traction Applications

Parameter Identification Of Inverter-Fed Induction Motors: A Review

A Parameter Optimization Design Method for Single-Phase Dual Active Bridge AC-DC Converter

Moving Discretized Control Set Model Predictive Control with Dominant Parameter Identification Strategy for Dual Active Bridge Converters

Parameter Design for Suppressing Current Distortion Caused by DC Bias in Dual-Active-Bridge Converters

A Coupled Inductor Scheme for CLLC Bidirectional Converter and Optimized Current Detection Method

Online Identification of Inductance and Flux Linkage for SPMSMs Decoupled from Resistance Voltage Drop and VSI Nonlinearity

A Parameter Design Method and a Fixed-Frequency Control Strategy for the Three-Phase DAB-SRC Based on the Time Domain Analytical Model

Parameter Identification of DFIG Converter Control System Based on WOA

The Online Parameter Identification Method of Permanent Magnet Synchronous Machine under Low-Speed Region Considering the Inverter Nonlinearity

A Parameter Identification Method For General Inverter-Fed Induction Motor Drive

Parameter Identification of Doubly-Fed Induction Generator by the Levenberg-Marquardt-Fletcher Method