Abstract:The higher temperature in the hot summer area will seriously damage the safety and comprehensive performance of the asphalt pavement, thus it must be cooled down quickly and orderly. At present, the cooling pavements are designed mainly based on engineering experience, and the quantitative relationship between design objective and variable is not constructed during the design process. In addition, it is difficult to determine whether the material distribution of cooling pavement is optimal. These limit the further improvement of the pavement cooling effect. In this study, the relationship between the design objective (minimum average temperature of upper layer) and design variable (thermal conductivity of pavement) of cooling pavement was built by numerical simulation, and the cooling pavement with the best cooling effect was obtained by topological optimization technology. The influence of the initial value and distribution of the thermal conductivity on the average temperature were explored during the design process. The thermal effect analysis and thermal resistance were used to determine cooling mechanism of optimized cooling pavement. The topology optimization results demonstrated that the minimum average temperature could be obtained when the initial value of the thermal conductivity gradually increased with the increase in pavement depth. The optimized cooling pavement showed good cooling effect at night. The thermal effect analysis results showed that the design of optimized cooling pavement reduced the net heat absorption and the heat transfer efficiency of the pavement, and increased the thermal resistance inside the pavement, thus achieving the pavement cooling. Compared with the ordinary asphalt pavement, the pavement surface temperature and interior temperature could be reduced by up to 9.18 °C and 13.29 °C, respectively. The maximum heat absorption, dissipation and net heat flux absorption of the optimized cooling pavement were decreased by 65.59 %, 63.87 % and 59.40 %, respectively. The reduction of the net heat flux absorption and heat release in the optimized cooling pavement are conducive to mitigating the high temperature rutting and the heat island effect at night, respectively. Finally, the indoor irradiation test was carried out to evaluate the cooling effect of optimized model. The temperatures of optimized group at 7 cm and surface were 5.29 °C and 2.5 °C lower than those of control group, respectively. The effectiveness of the topology optimization design for cooling pavement were verified.

Laboratorial Investigation on Optical, Thermal and Pavement Performance of Biomimetic Dark Reflective Coatings with Composite Structure for Pavement Cooling

Development of Super Road Heat-Reflective Coating and Its Field Application

Preparation and Properties of New Thermal Reflective Coating for Asphalt Pavement

Evaluation of cooling effect and pavement performance for thermochromic material modified asphalt mixtures under solar radiation

A novel functional coating with 2DMts/SA phase change material as filler and its pavement temperature regulation performance

Comparative investigation of mechanical and cooling performance between thermochromic road materials prepared by wet/dry process: For low-carbon production and sustainable service

Mitigation of Urban Heat Island Effects by Thermochromic Asphalt Pavement

Improving outdoor human-thermal environment by optimizing the reflectance of water-retaining pavement through subjective field-based measurements

Cooling Performance and Thermal Radiation Model of Asphalt Mixture with Modified Infrared Powder

Assessment of the effectiveness of cool pavements on outdoor thermal environment in urban areas

Multi-functional composite coating based on the dual effects of cooling and exhaust gas degradation

Cooling optimization of asphalt pavement by topology optimization and cooling mechanism analysis

Development of two-dimensional nano Mts/SA phase change materials for self-adjusting temperature of pavement

Enhancing thermal conductivity of cement-based composites by optimizing pores and adding pitch-based carbon fibers for pavement cooling

Experimental study on the thermal characteristics of urban mockups with different paved streets

Building the cooling roads with high thermal conductivity pavements to relieve urban heat island effect

Study on the Photothermal Performance of a "Thermal Shielding" Coating Using Tungsten Bronze as Functional Material for Asphalt Pavement

Micrometeorological effects and thermal-environmental benefits of cool pavements: Findings from a detailed observational field study in Pacoima, California

Combating Urban Heat Island Effect—A Review of Reflective Pavements and Tree Shading Strategies

Research on the performance of temperature responsive asphalt mixture with thermochromic material