Abstract:Accurate modelling of spray combustion process is essential for efficiency improvement and emissions reduction in practical combustion engines. In this work, both unsteady Reynolds-averaged Navier-Stokes (URANS) simulations and large eddy simulations (LES) are performed to investigate the effects of spray and turbulence modelling on the mixing and combustion characteristics of an n-heptane spray flame in a constant volume chamber at realistic conditions. The non-reacting spray process is first simulated with URANS to investigate the effects of entrainment gas-jet model on the penetration characteristics and fuel vapor distributions. It is found that the droplet motion near the nozzle has significant influence on the fuel vapor distribution, while the liquid penetration length is controlled by the evaporation process and insensitive to gas-jet model. For the case considered, both URANS with the gas-jet model and large eddy simulations can properly predict the vapor penetration. For the combustion characteristics, it is found that LES yields better predictions in the global combustion characteristics. The URANS with gas jet model yields a comparable flame length and lift-off-length (LOL) to LES, but results in a larger ignition delay time compared to the experimental data. Another focus of this work is to qualify the convergence characteristics of the dynamic adaptive chemistry (DAC) method in these transient combustion simulations, where DAC is applied to reduce the mechanism locally and on-the-fly to accelerate chemistry calculations. The instantaneous flame structures and global combustion characteristics such as ignition delay time, flame lift-off length and emissions are compared between simulations with and without DAC. For URANS, good agreements are observed both on instantaneous flame structures and global characteristics. For LES, it is shown that the errors incurred by DAC are small for scatter distributions in composition space and global combustion characteristics, while they may significantly affect instantaneous flame structures in physical space. The study reveals that for DAC application in transient simulations, global or statistic information should be used to assess the accuracy, such as manifolds in composition space, conditional quantities and global combustion characteristics. For the cases investigated, a speed-up factor of more than two is achieved by DAC with a 92-species skeletal mechanism with less than 0.2 % and 3.0 % discrepancy in ignition delay and LOL, respectively.

Improved Methods for Mixing-Limited Spray Modeling

The Eulerian Lagrangian Mixing-Oriented (ELMO) Model

A DNS evaluation of mixing and evaporation models for TPDF modelling of nonpremixed spray flames

Large-Eddy Simulation of ECN Spray A: Sensitivity Study on Modeling Assumptions

A new robust modeling strategy for multi-component droplet heat and mass transfer in general ambient conditions

Numerical Models For Viscoelastic Liquid Atomization Spray

Three-component volume of fluid method coupling with interface compression method and Eulerian–Lagrangian spray atomization surface density model for prediction of cavitating sprays

CFD unified approach under Eulerian-Lagrangian framework for methanol and gasoline direct injection sprays in evaporative and flash boiling conditions

Direct numerical simulation of three-dimensional swirling n-heptane spray flames

Three-Dimensional Simulation Of Effervescent Atomization Spray

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Simulating low temperature diesel combustion with improved spray models

A spray flamelet/progress variable approach combined with a transported joint PDF model for turbulent spray flames

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Modeling the Dense Spray Regime Using an Euler-Lagrange Approach With Volumetric Displacement Effects

Spray flames in an air-heptane swirling combustor

Computational Modeling and Analysis of Diesel-fuel Injection and Autoignition at Transcritical Conditions

Diesel engine spray modeling with lattice Boltzmann method

A Reduced-order Model for Multiphase Simulation of Transient Inert Sprays

Effects of Spray and Turbulence Modelling on the Mixing and Combustion Characteristics of an N -Heptane Spray Flame Simulated with Dynamic Adaptive Chemistry

High-Fidelity Multi-Scale Simulation of Swirled Air-blast Atomization with Comparison against Experiments