Abstract:The degradation of inverted metamorphic fourjunction (GaInP/GaAs/In 0.3 Ga 0.7As/In 0.58 Ga 0.42As, IMM4J) solar cells irradiated by 1-MeV electrons was investigated via their spectral responses and the characterization of their electrical properties. As in the case of traditional three-junction (TJ) GaInP/GaAs/Ge solar cells, the electrical properties (Isc, Voc, and Pmax) decrease with the logarithmic change of the electron fluence. The degradation of open-circuit voltage (Voc) is slightly more pronounced than that of Isc in IMM4J solar cells because of the sum rule for Voc and the limit rule for Isc. The spectral response analysis showed that an In 0.3 Ga 0.7As subcell was the most damaged subcell in the irradiated IMM4J solar cell, but an In 0.58 Ga 0.42 As subcell had the lowest initial short-circuit current density (J sc), whichwas maintained throughout the irradiation test. We therefore focused on the In 0.58Ga 0.42 As subcell. Deep-level transient spectroscopy (DLTS) experiments were realized to study emission and capture processes in two special full configurations of In 0.58 Ga 0.42As and In 0.3Ga 0.7 As subcells of the IMM4J solar cell. DLTS measurements reveal a dominant electron trap at 0.52 eV below the conduction band (E c) of In 0.58 Ga 0.42As, and the electron trap gradually evolved into E c -0.46eV and E c-0.58eV after 1-MeV electron irradiation. Based on the first-principles calculation, E c-0.46 eV and E c -0.58 eV can be assigned asV0 Ga /V-1 Ga and V0 In /V- 1 In, respectively. However, only one shallow level E c0.03eV was observed within the bandgap of In 0.3 Ga 0.7As after irradiation with DLTS detection. We summarize the issues faced for the space application of IMM4J solar cells by comparing the spectral responses of IMM3J, IMM4J, and TJ solar cells. Finally, the optimization of the design and fabrication of IMM solar cells are proposed.

Effects of localized tensile stress on GaAs solar cells revealed by absolute electroluminescence imaging and distributed circuit modeling

Thermomechanical stress in solar cells: Contact pad modeling and reliability analysis

Modeling and Simulation of Graphene-Gated Graphene-Gaas Schottky Junction Field-Effect Solar Cell for Its Performance Enhancement

Boosting quantum-structured solar cell light absorption through compressively strained superlattices

Strategies for minimizing induced thermomechanical stress in glass–glass PV modules with half cells identified using finite element modelling

Investigation of degradation characteristics of electron irradiated GaInP/InGaAs/Ge solar cell by numerical simulation model

Inhibited Crack Development by Compressive Strain in Perovskite Solar Cells with Improved Mechanical Stability

Visualizing localized, radiative defects in GaAs solar cells

Effects of quasi-fermi level splitting and band tail states on open circuit voltage towards high-efficiency Cu(In,Ga)Se 2 solar cells

1 MeV electron irradiation effect and damage mechanism analysis of flexible GaInP/GaAs/InGaAs solar cells

Thermal Residual Stress Analysis of Soldering and Lamination Processes for Fabrication of Crystalline Silicon Photovoltaic Modules

Thermo-mechanical stress modeling and experimental investigation on micro-cracks in tilling ribbon photovoltaic modules during lamination and mechanical load test

Microstress for Metal Halide Perovskites Solar Cells: From Source to Influence and Management

Strain-modulated anomalous circular photogalvanic effect in p-type GaAs

Electron Irradiation Effects and Defects Analysis of the Inverted Metamorphic Four-Junction Solar Cells

Effect of ELA Energy Density on Self-Heating Stress in Low-Temperature Polycrystalline Silicon Thin-Film Transistors

Enhanced Electronic and Optical Properties of Multi-Layer Arsenic Via Strain Engineering.

Thermo-mechanical stress modelling and fracture analysis on ultra-thin silicon solar cell based on super multi-busbar PV modules

Strain Engineering of Metal Halide Perovskites on Coupling Anisotropic Behaviors

Degradation Mechanism of III-V Triple Junction Solar Cells Analyzed Using Step Stress Tests

The Impacts and Origins of A-site Instability in Formamidinium-Cesium Lead Iodide Perovskite Solar Cells Under Extended Operation