Cellulose-Based Triboelectric Nanogenerator Prepared by Multi-Fluid Electrospinning for Respiratory Protection and Self-Powered Sensing

Jiaqi Huang,Yan Zhang,Haijiao Yu,Guangping Han,Wanli Cheng
DOI: https://doi.org/10.3390/act13050178
IF: 2.6
2024-05-09
Actuators
Abstract:A cellulose-based triboelectric nanogenerator (TENG) with fiber–wave–arch structure was prepared through a multi-fluid electrospinning process for air filtration and wind sensing. The TENG is composed of a cellulose nanocrystals (CNC)/zein membrane and a cyanoethyl cellulose (CEC)/polyvinylidene fluoride (PVDF) membrane. The results show that the addition of CEC improves the output performance and filterability of TENG. At the same time, the reduced diameter and high roughness of CEC/PVDF nanofibers improve the output performance of the TENG. The TENG with a 6 wt% CEC/PVDF solution concentration has the highest output performance with a short-circuit current of 3.30 μA and an open-circuit voltage of 10.01 V. The particle filtration of 12 wt% CEC/PVDF TENG is the best, showing an efficiency of 98.84% and a pressure drop of 50 Pa. The TENG also has a good formaldehyde filtration capability with an efficiency of 92% at 0.25 mg/m3. The TENG shows great potential in self-powered sensor applications.
engineering, mechanical,instruments & instrumentation
What problem does this paper attempt to address?
The main problem this paper attempts to address is the development of a cellulose-based triboelectric nanogenerator (TENG) with a fiber-wave-arch structure prepared through multi-fluid electrospinning technology, for applications in air filtration, wind sensing, and self-powered sensing. Specifically, the paper focuses on the following aspects: 1. **Improving TENG output performance**: Enhancing the electrical output performance and filtration capability of TENG by adding cyanoethyl cellulose (CEC). 2. **Optimizing air filtration performance**: Investigating the effect of different concentrations of CEC/PVDF solutions on the filtration performance of TENG, particularly in filtering particulate matter and harmful chemical gases such as formaldehyde. 3. **Achieving multifunctional applications**: Developing a TENG that can be used for both energy harvesting and self-powered sensing, especially for wearable electronic devices for respiratory protection and monitoring respiratory diseases. ### Main Research Content - **Material Selection and Structural Design**: Polyvinylidene fluoride (PVDF) was chosen as the polymer matrix for the composite material due to its good spinnability and significant negative charge. Cyanoethyl cellulose (CEC) was introduced for its high dielectric properties to increase the charge density of TENG. - **Multi-fluid Electrospinning Technology**: The micro/nano structure of the prepared nanofibers was controlled by utilizing the evaporation rates of different solvents and the solidification rates of polymers, successfully preparing CEC/PVDF nanofibers with high surface roughness. - **Performance Testing**: The microstructure and morphology of the nanofiber membranes were characterized using scanning electron microscopy (SEM), contact angle measurement system, and Fourier-transform infrared spectroscopy (FTIR). The open-circuit voltage and short-circuit current of TENG were tested, and its filtration performance, particularly in filtering particulate matter and formaldehyde, was evaluated. ### Experimental Results - **Electrical Output Performance**: The electrical output performance of TENG significantly improved after adding CEC. The TENG with a 6 wt% CEC/PVDF solution concentration exhibited the highest output performance, with a short-circuit current of 3.30 µA and an open-circuit voltage of 10.01 V. - **Filtration Performance**: The TENG with a 12 wt% CEC/PVDF solution concentration achieved the highest particulate filtration efficiency of 98.84% with a pressure drop of 50 Pa. The formaldehyde filtration efficiency also reached 92%. - **Structural Advantages**: The TENG with a multi-level structure (fiber-wave-arch) showed excellent performance in energy harvesting and self-powered sensing, making it promising for applications in respiratory protection and health monitoring. ### Conclusion This study provides a new multi-fluid hybrid electrospinning strategy, successfully preparing a cellulose-based TENG with high output performance and multifunctional application potential. This TENG can effectively harvest energy and be used for air filtration and self-powered sensing, particularly suitable for applications in respiratory protection and monitoring respiratory diseases.