Abstract:<p>Modern electronic devices with high heat flux increasingly exceed the capability of thermal management method. Two-phase thermal dissipation devices such as vapor chambers offer effective method for high heat flux cooling. Various new structural designs of vapor chambers are used as effective thermal control methods for high heat flux devices. However, the optimization criteria for the capillary wick structures are different. The combinations between the structural surface parameters and pore size of the capillary wick are different, while their influence on the heat transfer performance need to be studied. In this work, it is reported that the fabrication and thermal performance of vapor chambers with multi-layer sintered wicks and multi-artery wick design for liquid supply. We numerically and experimentally characterize the two types of sintered multi-artery wick for replenishing liquid and escaping vapor effectively with high heat flux. Three kinds of combinations of different copper particle sizes were applied to the sintered wicks in order to balance the liquid collecting rate and flow resistance. The copper particles of large particle size (60 μm /100 μm /150 μm) in the upper layer wick and copper particles of small particle size (30 μm /50 μm /100 μm) the lower layer wick were applied in the vapor chambers. In the present study, as an evaluation criteria for capillary wick designs, the relationship between surface porosity, surface area and critical heat flux was analyzed to obtain the experimental optimization of structural design and pore size combination as 50/100 μm. It was found that with similar multi-artery structure wicks, higher surface area porosity can effectively increase the critical heat flux of the vapor chambers. Judging from the experiment results, the minimum through-plane direction heat transfer resistance of the vapor chamber is 0.1426 K/W, the minimum in-plane direction heat transfer resistance is 0.016 K/W, while the critical heat flux of the vapor chamber is 262 W/cm<sup>2</sup>.</p>

Study on the thermal performance of pulmonary vascular-inspired grooved vapor chamber

Experimental Investigation on the Thermal Performance of a Large-Size Aluminum Vapor Chamber for Multi-Point Heat Sources

Heat transfer performance analysis of an ultra-thin aluminum vapor chamber with serrated microgrooves

Enhanced Heat Spreading Performance of Printed Circuit Boards by Vapor Chamber Implementation

Performance Study of a Leaf-Vein-like Structured Vapor Chamber

An improved vapor chamber with enhanced two-phase transport by using structured surfaces

Thermal Performance of a Liquid-cooling Assisted Thin Wickless Vapor Chamber

Thermal performance of ultra-thin vapor chamber with etched micro-structure for electronics cooling

Experimental Investigation on Ultra-Thin Vapor Chamber with Composite Wick for Electronics Thermal Management

Vapor chamber with two-layer liquid supply evaporator wick for high-heat-flux devices

Experimental investigation of post and vented vapor chamber designs for high heat flux dissipation

A Novel Vapor Chamber and Its Performance

Enhancing heat transfer performance in 3D-printed integrated vapor chamber using composite structures

Experimental investigation on the thermal performance of vapor chamber in a compound liquid cooling system

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Dual-scale porous/grooved microstructures prepared by nanosecond laser surface texturing for high-performance vapor chambers

Fabrication and characterization of ultra-thin vapour chambers with printed copper powder wick

A novel ultra-thin vapor chamber with composite wick for portable electronics cooling

Design Optimization of Graded Three-Dimensional Micropillar Wicks for Vapor Chamber Evaporators

Experimental study on ultra-thin silicon-based VC for chip-level heat dissipation

Experimental investigation on enhanced flow and heat transfer performance of micro-jet impingement vapor chamber for high power electronics