Effect of polyol bonding agent on the mechanical properties of hydroxyl‐terminated block copolyether based composite propellant with low aluminum content

Wu Yang,Wenhao Liu,Mengze Zheng,Cong Zhu,Tianqi Li,Yunjun Luo
DOI: https://doi.org/10.1002/app.56004
IF: 3
2024-07-19
Journal of Applied Polymer Science
Abstract:Using bonding agents as a "bridge" to enhance the interaction between solid fillers and adhesive matrix, thereby improving the mechanical properties of propellants. A polyol bonding agent (BA) was utilized to enhance the mechanical properties of propellant with low aluminum content. Through scanning electron microscope (SEM) and X‐ray photoelectron spectroscopy (XPS) analysis, it was discovered that BA can physically bond to the surfaces of ammonium perchlorate (AP) and hexogen (RDX). The results of mechanical testing showed that the use of BA can significantly improve the mechanical properties of propellants. Specifically, as the amount of BA increases, the maximum tensile strength (σm) of the propellant also increases, the fracture elongation (εb) initially increases and then decreases, the "dewetting ratio" continuously decreases, and the creep resistance of the propellant also increases. At a BA content of 0.2%, the σm of the propellant reaches 0.6 MPa, the εb exceeds 50%, and the "dewetting ratio" is less than 1.1.
polymer science
What problem does this paper attempt to address?