Abstract:The unmatched seismic theoretical rotations from the experimental data led the researchers to develop the reduced micropolar theory in seismology. The study here mainly focuses on the finite-fault simulations for rotations and strains in the near-fault region for a causative strike-slip fault of the 6.5 event. Firstly, the parametric investigation is performed on additional material parameters, viz. micropolar couple modulus and microinertia density to the rotations and strains. Secondly, the seismic source parameters such as rupture velocity, slip velocity, burial fault depth, earthquake magnitude, hypocenter location and slip amplitude are varied to see the effect of these parameters on rotations and strains seismograms. The results in different scenarios are compared to the classical elastic medium and reduced micropolar medium. The rotations obtained using reduced micropolar theory are comparatively high to the rotations of classical elastic theory. Although, the obtained displacements in both theories are almost the same. The normal strains in both theories are equivalent, while the shear strains differ as the shear strains in reduced micropolar theory are asymmetric and rotation dependent. The increment in the value of microinertia density increases the rotations, however, the converse is true in the case of micropolar couple modulus. The parametric analysis results demonstrate that near-fault ground rotations and strains are highly sensitive to changes in the seismic source parameters. For instance, modelling the medium homogeneous decreases the amplitude and duration of seismograms sharply compared to layered media. Finally, peak ground contours of displacements, rotations and strains are presented for different hypocenter locations using grid point simulation, and it is found that a change of hypocenter location alters the spatial distribution of peak values of these quantities in the near-fault region of the surface plane. Nevertheless, the maximum limit of peak values over the entire ground surface is near equal for the different hypocentral locations.

Deformation of a layered elastic medium due to an inclined long strike-slip fault

Deformation of an orthotropic layer overlying a rough-rigid base due to surface loads

Ground deformation due to interaction between infinite and finite dip-slip fault in a viscoelastic half-space of standard linear solid (SLS)

Deformation of a Half-Space from Anelastic Strain Confined in a Tetrahedral Volume

Effects on the Earth Surface Deformation by Asymmetric Strike Slip on Fault Plane

Axisymmetric Indentation of Circular Rigid Plate on Layered Elastic Halfspace with Transverse Isotropy

Elastic Deformation Due to Polygonal Dislocations in A Transversely Isotropic Half-Space

Fault rupture propagation through stratified sand–clay deposits and engineered earth structures: a meshfree and critical-state modeling approach

Bending-like behavior of thin wedge-shaped elastic fault blocks

Finite-fault simulations for rotations and strains in the near-fault subjected to layered reduced micropolar half-space

Indentation of a Plate on a Thin Transversely Isotropic Elastic Layer

Surface motion of a layered medium having an irregular interface due to incident plane SH waves

Fault Networks in Triaxial Tectonic Settings: Analog Modeling of Distributed Continental Extension With Lateral Shortening

Asymptotic behavior of Structures made of Plates

Transverse surface wave in non-planar layered nearly incompressible elastic structure having imperfect contact

Fault geometry invariance and dislocation potential in antiplane crustal deformation: physics-informed simultaneous solutions

Indentation of a two-dimensional bonded elastic layer with surface tension

Semi-discrete modeling of systems of wedge disclinations and edge dislocations via the Airy stress function method

Analysis of a dislocation model for earthquakes

Spheroidal Sliding Inclusion in an Elastic Half-Space

Relating slip behavior to off‐fault deformation using physical models