Abstract:Numerical and Physical Modeling of Flexural Slip Phenomena and Potential for Fault Movement. In the course of a site evaluation study for a proposed liquified natural gas (LNG) terminal on the West Coast of the United States, geomechanical studies were undertaken to complement conventional geological investigations. The geologic structure under investigation was a flexural fold formed by a compressional tectonic environment. It consists of an approximately 4000 foot thick shale deposit, with bedding planes dipping roughly 45 degrees and outcropping at the rock surface. Continuous folding had produced several reverse bedding plane faults, with slip separations at the bedrock surface of up to 8 feet in the last 100 000 to 200 000 years.The purpose of the analysis was to evaluate the amount of fault slippage to be expected from a postulated instantaneous strain release caused by any imaginable trigger event. A plane strain finite element analysis, with elasto-plastic solid elements, and slip surfaces, to represent existing and potential faults was performed. In addition, in order to study the 3-dimensional effects of faults crossing the bedding plane strike, physical modeling was also performed. The model geometry and boundary conditions of the numerical model were based on geological observations and measurements. Other input data were derived from an extensive rock testing program involving field and laboratory testing techniques. In situ measurements of normal stresses in the plane of bedding were performed utilizing over-coring techniques in 45 degree-inclined borings.After application of gravity, the numerical model was laterally compressed to reach a characteristic state of stresses indicated by an upper bound of storable elastic strain energy within the system. This state of limiting equilibrium represented the in situ stress state for the strain release analysis. By comparing the so calculated stresses, with the stresses measured in the field, at corresponding locations, it was possible to check the analysis results. The calculated stresses at limiting equilibrium were roughly twice the measured values, indicating conservative analysis assumptions.The potential bedrock offset was evaluated without addressing the likelihood of its occurring. For this purpose, it was assumed that the existing shear strength of a selected bedding plane would drop to its residual value, due to transient overstressing by some unspecified event. Several computer runs, taking into account the statistical uncertainties of the most important material parameters, suggested a most likely amount of potential future bedrock offset of less than 1 inch, due to elastic strain release.

Relating slip behavior to off‐fault deformation using physical models

Two sides of a fault: Grain-scale analysis of pore pressure control on fault slip

On the importance of 3D stress state in 2D earthquake rupture simulations with off-fault deformation

Three‐dimensional Models of Deformation Near Strike‐slip Faults

The physics of fault friction: Insights from experiments on simulated gouges at low shearing velocities

Coupling 3D geodynamics and dynamic earthquake rupture: fault geometry, rheology and stresses across timescales

Fault Valving and Pore Pressure Evolution in Simulations of Earthquake Sequences and Aseismic Slip

Depth Dependence of Coseismic Off-Fault Damage and its Effects on Rupture Dynamics

Fault friction during simulated seismic slip pulses

A Model for Athermal Strain Localization in Dry Sheared Fault Gouge

Analysis of Near-Field Stresses in an Analogue Strike-Slip Fault Model

How Fault‐Normal and Shear‐Parallel Stiffness Influence Frictional Sliding Behavior

Evolution of the Deformation Field and Earthquake Fracture Precursors of Strike-Slip Faults

Flow-to-Friction Transition in Simulated Calcite Gouge: Experiments and Microphysical Modeling

Deformation and Frictional Failure of Granular Media in 3D Analog and Numerical Experiments

Numerical investigation of progressive damage and associated seismicity on a laboratory fault

Fault-network geometry influences earthquake frictional behaviour

Numerical and Physical Modeling of Flexural Slip Phenomena and Potential for Fault Movement

Using a landscape fingerprint to identify changes in fault-slip behavior

Off-fault deformation feedback and strain localization precursor during laboratory earthquakes

Intermittent Criticality Multi‐Scale Processes Leading to Large Slip Events on Rough Laboratory Faults