Advanced LIGO two-stage twelve-axis vibration isolation and positioning platform. Part 1: Design and production overview

F. Matichard,B. Lantz,K. Mason,R. Mittleman,B. Abbott,S. Abbott,E. Allwine,S. Barnum,J. Birch,S. Biscans,D. Clark,D. Coyne,D. DeBra,R. DeRosa,S. Foley,P. Fritschel,J.A. Giaime,C. Gray,G. Grabeel,J. Hanson,M. Hillard,J. Kissel,C. Kucharczyk,A. Le Roux,V. Lhuillier,M. Macinnis,B. O’Reilly,D. Ottaway,H. Paris,M. Puma,H. Radkins,C. Ramet,M. Robinson,L. Ruet,P. Sareen,D. Shoemaker,A. Stein,J. Thomas,M. Vargas,J. Warner
DOI: https://doi.org/10.1016/j.precisioneng.2014.09.010
IF: 3.315
2015-04-01
Precision Engineering
Abstract:New generations of gravity wave detectors require unprecedented levels of vibration isolation. This paper presents the final design of the vibration isolation and positioning platform used in Advanced LIGO to support the interferometer's core optics. This five-ton two-and-half-m wide system operating in ultra-high vacuum. It features two stages of isolation mounted in series. The stages are imbricated to reduce the overall height. Each stage provides isolation in all directions of translation and rotation. The system is instrumented with a unique combination of low noise relative and inertial sensors. The active control provides isolation from 0.1Hz to 30Hz. It brings the platform motion down to 10−11 m/Hz at 1Hz. Active and passive isolation combine to bring the platform motion below 10−12 m/Hz at 10Hz. The passive isolation lowers the motion below 10−13 m/Hz at 100Hz. The paper describes how the platform has been engineered not only to meet the isolation requirements, but also to permit the construction, testing, and commissioning process of the fifteen units needed for Advanced LIGO observatories.
What problem does this paper attempt to address?