Multi-DOF Isolation and Alignment with Quiet Hydraulic Actuators
C Hardham,B Abbott,R Abbott,G Allen,R Bork,C Campbell,K Carter,D Coyne,D DeBra,T Evans,J Faludi,A Ganguli,J Giaime,M Hammond,W Hua,J Kern,J LaCour,B Lantz,M Macinnis,K Mailand,K Mason,R Mittleman,J Nichol,J Niekerk,N Robertson,D Ottaway,H Overmier,J Phinney,B Rankin,D Sellers,P Sarin,D Shoemaker,G Traylor,S Wen,M Zucker
2004-01-01
Abstract:The goal of Advanced LIGO (Laser Interferometer Gravitational-Wave Observatory) is to detect gravitational waves. Detection is conducted by precisely monitoring the distance between reference mirrors with an interferometer. The perceived relative motion of the reference mirrors from gravitational waves is expected to be very small by comparison to seismic disturbances. A multi-stage isolation and alignment system is in development to hold the interferometer optics at their operating point and isolate them from external disturbances in all six degrees of freedom (DOF). While this problem is broadband, this paper focuses on the design of a unique actuator for a system which specifically addresses the lowfrequency isolation and alignment requirements [1]. Based on predictions for low-frequency disturbances and other specifications of the total suspension [2], the requirements for the low-frequency system actuator are challenging. Four specifications define this challenge: max force greater than 2000 N; throw of ±1 mm; bandwidth from zero frequency to at least 10 Hz; and noise not to exceed 10−9 m/ √ Hz at 1 Hz. While there are other actuators that meet one or more of these requirements, the ‘Quiet Hydraulic’ actuator is one known solution which can meet all of these requirements without the nonlinear, stick-slip behavior typical of mechanical solutions or appreciable hysteresis.