Abstract:Objective To provide the scientific basis for investigating and developing neutron source of boron neutron capture therapy(BNCT) by means of studying the characterization of~7Li(P,n)~7Be neutron yields iuduced by an accelerator. Methods When acceleration voltage were 3.0, 2.8 and 2.6 MeV.proton fluxes were accelerated to strike Li target to produce~7Li(P,n)~7Be reaction,and the produced neutron fluxes activated~(115)In metal foils at different directions. γ-rays emitted from~(115)In foil neutron threshold reaction were measured. Radioactivity of~(115)In foil were calculated and differential cross sections of~7Li(P,n)~7Be were analyzed.Results Neutron fluxes with numerous energy sources were produced at different directions after the nuclear reaction~7Li(P,n)~7Be.When the neutron fluxes had the same directions with the proton beam, the differential cross sections of ~7Li(P,n)~7Be were about 50 mb/mr,but the differential cross sections declined to 30 mb/mr when the angles between the neutron fluxes and the proton beams were 60 degree.Some neutrons with higher energy reached the behind area because of the elastic scattering of neutrons and affected the differential cross sections of the field.Conclusions The neutron distributions can be easily determined simultaneously at several directions via foil activation method.The influence of elastic scattering of neutrons and other metals should be taken into account. After the production of~7Li(P,n)~7Be was slowed down,thermal neutron and epithermal neutrons which were suitable for BNCT should be acquired.As BNCT neutron source,the flux of proton beam should be over 10 mA. Key words: Neutron; Differential cross section; Boron neutron capture therapy; Foil activation; Accelerator

Distribution of neutron energy and yield variations with nat Li target thickness at proton energies between 8 and 20 MeV

Generation of neutron spectra and emission yields from proton-induced reactions on nat C and nat Li targets using CR-39 detectors

Neutron yield calculation of p-Li thick target by using PHITS with JENDL-4.0/HE and ENDF/B-VII for BNCT application

Influence mechanism of lithium surface oxidation on neutron yield of lithium target for accelerator-based neutron source

Comparisons on thin and thick neutron target for low energy proton beam

Neutron Yields of Thick Be Target Bombarded with Low Energy Deuterons

The Influence of Target Material and Thickness on Proton Energy and Angular Distribution

High-power electron beam tests of a liquid-lithium target and characterization study of (7)Li(p,n) near-threshold neutrons for accelerator-based boron neutron capture therapy

Measurements Of Neutron-Induced Light-Charged Particle Emission Reactions

Problem of the spallation neutron production source related to accelerator-driven systems

Measurement of differential and angle-integrated cross sections of the 6Li(n,t)4He reaction in the MeV neutron energy range

Thickness-dependent neutron detection efficiency of LiF-Si-based active neutron detector for boron neutron capture therapy

Effects of neutron-skin thickness on light-particle production

Thick target yields of proton induced reactions on natural molybdenum

Measurement Of Total Reaction Cross Section For Neutron-Rich Nucleus Li-11 On Si-28 Target At Medium Energy

Measurements of Differential and Angle-Integrated Cross Sections for the 10b(n, Α)7li Reaction in the Neutron Energy Range from 1.0 Ev to 2.5 MeV *

Dependence of neutron rate production with accelerator beam profile and energy range in an ADS-TRIGA RC1 reactor

Characterization Of~7li(p,n)~7be Neutron Yields from an Accelerator for Boron Neutron Capture Therapy

Development of a quasi-monoenergetic neutron field using the 7Li(p,n)7Be reaction in the energy range from 250 to 390 MeV at RCNP

Yield Ratio of Neutrons to Protons in ^12 C(d,n) ^13 N and ^12 C(d,p) ^13 C from 0.6 to 3 MeV

Neutron flux evaluation model provided in the accelerator-based boron neutron capture therapy system employing a solid-state lithium target