Abstract:Synthesis of thin zeolite membranes in the sub-micron range is desirable but a great challenge. Despite the successful synthesis of ultrathin Silicalite-1 and CHA membranes, the pursuit of SAPO-34 membranes thinner than 1 μm remains difficult. Herein, thin SAPO-34 membranes were prepared in concentrated gel by conventional hydrothermal synthesis. Concentrated membrane gel (TEAOH/Al2O3 = 4 and H2O/Al2O3 = 10) enhanced nucleation and facilitated the formation of small SAPO-34 crystals and therefore thin membranes. High TEAOH/Al2O3 ratio and special mixing sequence resulted into a homogeneous membrane gel with low viscosity which is beneficial for membrane synthesis with high reproducibility. Al(OH)3 as Al source led to formation of cubic SAPO-34 crystals which facilitated crystal intergrowth and reduced defects. These membranes (∼1.2 μm thick) exhibited high CO2 permeance of 3.9 × 10−6 mol/(m2 s Pa) and CO2–CH4 selectivity of 152 for equimolar CO2–CH4 mixture at room temperature and 0.14 MPa pressure drop. Further optimization of aging treatment or limiting the excessive membrane growth by a two-step hydrothermal synthesis + dry gel conversion method, the membrane thickness was successfully reduced to ∼0.9 μm, which increased the CO2 permeance to ∼5.0 × 10−6 mol/(m2 s Pa) without sacrificing CO2–CH4 selectivity.

Efficient synthesis of thin SSZ-13 membranes by gel-less method

Fast synthesis of thin SSZ-13 membranes by a hot-dipping method

Improved Synthesis of Hollow Fiber SSZ‐13 Zeolite Membranes for High‐Pressure CO2/CH4 Separation

Synthesis of thin SAPO-34 zeolite membranes in concentrated gel

ZSM-5 zeolite membranes prepared from a clear template-free solution

Effects of the synthesis hydrogel on the formation of zeolite LTA membranes

The preparation of zeolite NaA membranes on the inner surface of hollow fiber supports

Zeolite membranes on hollow fiber supports

Sustainable synthesis of highly water-selective ZSM-5 membrane by wet gel conversion

High Performance Zeolite Lta Pervaporation Membranes on Ceramic Hollow Fibers by Dipcoating-Wiping Seed Deposition

Thin SAPO-34 zeolite membranes prepared by ball-milled seeds

A Facile Preparation of High Flux NaA Zeolite Membranes by Direct Secondary Growth of Wet Gel Layer

Synthesis Optimization of SSZ-13 Zeolite Membranes by Dual Templates for N2/NO2 Separation

Microstructure Manipulation of MFI-type Zeolite Membranes on Hollow Fibers for Ethanol–water Separation

Preparation of high-performance zeolite NaA membranes in clear solution by adding SiO2 into Al2O3 hollow-fiber precursor

Fast synthesis of thin all-silica DDR zeolite membranes with inorganic base as mineralizing agent for CO2-CH4 separation

Preparation of zeolite MFI membranes on alumina hollow fibers with high flux for pervaporation

High-performance zeolite membranes on inexpensive large-pore supports: highly reproducible synthesis using a seed paste.

Synthesis of Hierarchical LTA Zeolite Membranes by Vapor Phase Transformation

Zeolite Imidazolate Framework Membranes on Polymeric Substrates Modified with Poly(vinyl Alcohol) and Alginate Composite Hydrogels.

High performance zeolite NaA membranes synthesized on the inner surface of zeolite/PES–PI blend composite hollow fibers