Abstract:RATIONALE:Continuous-flow isotope ratio mass spectrometry (CF-IRMS) is a specialized technique used to quickly analyze very small amounts of sample. We have used CF-IRMS to assess the influences of sample weight and relative carbon content on the accuracy and precision of the δ13 C values of micro amounts of carbonate and non-carbonate in silicate rocks.METHODS:The analytical work was performed on a Gasbench II (GB) sample preparation device and on an Elemental Analyzer (EA), which were both interfaced to CF-IRMS instruments. Potential silicate matrix effects on the carbon isotopic analyses were investigated by measuring mixtures of calibrated carbon reference materials and quartz powder. The calibration lines, established by the measured raw values and the known values of three reference materials mixed with quartz powder, were used to calibrate the δ13 C values of basalt samples from eastern China.RESULTS:The δ13 C values measured by GB-CF-IRMS of one national carbonate reference material, GBW04416, deviate slightly from the known value for approximately 20-70 μg of carbonate contained in 4.5-mL vials; the smaller the sample size, the lower the measured δ13 C values. External precision better than 0.1‰ (1σ, n = 26) is achieved at a signal intensity for mass 44 of between 868 and 1614 mV, corresponding to a sample weight of 30.8-50.2 μg, whereas it is reduced to 0.27‰ (1σ, n = 34) at a signal intensity between 519 and 1614 mV, corresponding to a sample weight of 21.1-50.2 μg. In the EA-CF-IRMS experiments for non-carbonate carbon, at high carbon concentration (greater than 800 ppm) and at optimum sample weights, the accuracy and precision are both better than 0.2‰. For carbon concentrations less than 500 ppm, the measured δ13 C values deviate from the average by up to -1.2‰ and the precision is 0.74‰.CONCLUSIONS:The measured δ13 C values decrease substantially at lower carbon concentration and higher sample weights, and poorer precision is obtained. Suggestions are made to measure repeatedly the same carbon concentration of sample and reference materials in order to obtain not only reproducible, but also accurate carbon isotope ratios.

A New Calcite Reference Material for In-Situ Oxygen Isotope Analysis Using Secondary Ion Mass Spectrometry: Development and Application Constraints

NJUCal‐1: A New Calcite Oxygen Isotope Reference Material for Microbeam Analysis

Accurate and Efficient SIMS Oxygen Isotope Analysis of Composition-Variable Minerals: Online Matrix Effect Calibration for Dolomite

Accurate in Situ Oxygen Isotopic Analysis at High Resolution by Secondary Ion Mass Spectrometry Shows the Potential of Aragonite As a Reference Material

Development of two novel natural calcite reference materials for enhanced in situ elemental and Sr isotopic analysis.

Barite oxygen isotope reference materials for highly precise and accurate SIMS microanalysis

A High Precision Method for Calcium Determination in Seawater Using Ion Chromatography

In Situ Carbon Isotope Analysis by Laser Ablation MC-ICP-MS.

Barite, Anhydrite and Gypsum Reference Materials for in Situ Oxygen and Sulfur Isotope Ratio Measurements

Validation of Mg Isotopic Measurements for the Characterisation of Ten Carbonate Reference Materials with Ultra‐Low Mg Mass Fractions

An Online Method Combining a Gasbench II with Continuous Flow Isotope Ratio Mass Spectrometry to Determine the Content and Isotopic Compositions of Minor Amounts of Carbonate in Silicate Rocks.

Chromite Reference Materials and Matrix Effects in SIMS Oxygen Isotope Measurements

Simultaneous determination of the oxygen isotope ratio and volatile composition of apatite with high lateral resolution via nano-secondary-ion mass spectrometry

In Situ Analysis of Sulfur Isotopic Fractionation in Deep‐Sea Corals Using Secondary‐Ion Mass Spectrometry: Insights Into Vital Effects

In situ calcite U−Pb geochronology by high-sensitivity single-collector LA-SF-ICP-MS

Dolomite reference material synthesized by pressureless sintering for laser ablation MC-ICP-MS carbon and magnesium isotope analysis

Precise Carbon Isotopic Ratio Analyses of Micro Amounts of Carbonate and Non-Carbonate in Basalt Using Continuous-Flow Isotope Ratio Mass Spectrometry

Potential Orthopyroxene, Clinopyroxene and Olivine Reference Materials for in Situ Lithium Isotope Determination

High-Precision Measurements of 44ca/40ca Using Multiple-Collector Inductively Coupled Plasma Mass Spectrometry Without Collision-Cell Technology.

In Situ Oxygen Isotope Determination in Serpentine Minerals by Ion Microprobe: Reference Materials and Applications to Ultrahigh‐Pressure Serpentinites

Matrix Corrected SIMS In Situ Oxygen Isotope Analyses of Marine Shell Aragonite for High Resolution Seawater Temperature Reconstructions