Abstract:Ni-rich layered cathode materials are important candidates for lithium-ion batteries used for applications requiring high energy density, such as electric vehicles and mobile electronic devices. However, comparing with low Ni content NMC, Ni-rich NMCs frequently exhibit fast capacity decay and relatively shorter lifetime due to the formation of more reactive surface with high Ni content. Previous reports demonstrated that Ni-rich NMCs are sensitive to the CO 2 and water in the air during ambient storage, because of these oxidizing gases can lead to the formation of surface impurities such as Li 2 CO 3 and LiOH. [1] these surface impurities can react with electrolyte during the electrochemical cycling process and form a nonuniform cathode/electrolyte interface (CEI) layer. Surface instability of Ni-rich NMCs can also cause problems during the large-scale electrode preparation, and material storage. Research results reported in the literature have suggested that the degradation of Ni-rich NMCs could be attributed to the reduction of Ni and evolution of active oxygen species as well as the side reaction between the surface impurities and the electrolyte. [2-3] However, only limited experimental results have been reported about the formation mechanism of surface impurities and side reaction during the battery cycling for Ni-rich NMCs. Therefore, it is very important to develop an in-situ characterization method to reveal the CO 2 and moisture effects on the surface chemistry of Ni-rich NMCs. Synchrotron-based Ambient-Pressure XPS (AP-XPS) is a powerful technique with controllable gas environments and tunable energy. These enable us to probe the surface chemistry evolution of the samples in-situ in atmospheric gas environments with different depth profile. Taking these advantages, we have systematically investigated the CO 2 and moisture effect on the LiNi 0.94 Co 0.06 O 2 cathode material with and without Al doping using AP-XPS technique. Preliminary results showed that only Ni 2+ can be observed in NC sample surface after exposed to CO 2 environment even measured at 2000 eV with probing depth of ~9 nm. In contrast, characteristic peak of Ni 3+ still exists in NCA sample, even measured at 1200 and corresponding to probing depth of ~5.5 nm. These results show that better surface stability (less Ni 2+ at surface) can be achieved by Al doping. We also comprehensively investigated the depth profile of CEI layer of NMC cathode materials with different Ni content and found that CEI composition really depends on Ni content, dopant as well as the cut off voltage for charging. These results will be presented at the meeting. [1] You et al. Angewandte Chemie , 572018 (2018) 6480-6485. [2] Shizuka et al. Journal of Power Sources , 166 (2007) 233-238. [3] Jung et al. Journal of The Electrochemical Society , 165 (2) (2018) A132-A141. Acknowledgement The work was supported by the Assistant Secretary for Energy Efficiency and Renewable Energy, Vehicle Technology Office of the U.S. DOE through the Advanced Battery Materials Research (BMR) Program, including Battery500 Consortium under contract No. DE-SC0012704.

A multi-edge study: investigating Co oxidation states of pristine LiNi x Mn y Co 1-x-y O 2 cathode materials by high energy-resolution X-ray spectrometry

Monitoring the Formation of Nickel-Poor and Nickel-Rich Oxide Cathode Materials for Lithium-Ion Batteries with Synchrotron Radiation

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Surface Analysis of the Lithium-Rich Cathode Material Li<sub>1.2</sub>Mn<sub>0.54</sub>Co<sub>0.13</sub>Ni<sub>0.13</sub>Na<sub><i>x</i></sub>O<sub>2</sub> by Advanced Electron Microscopy

The stability and redox mechanisms of Ni-rich NMC cathodes: Insights from first-principles many-body calculations

Fundamental Linkage Between Structure, Electrochemical Properties, and Chemical Compositions of LiNi1-x-yMnxCoy O2 Cathode Materials

Direct Observation of Reductive Coupling Mechanism between Oxygen and Iron/Nickel in Cobalt‐Free Li‐Rich Cathode Material: An in Operando X‐Ray Absorption Spectroscopy Study

Probing the Thermal-Driven Structural and Chemical Degradation of Ni-Rich Layered Cathodes by Co/Mn Exchange

Decoupling the Roles of Ni and Co in Anionic Redox Activity of Li-rich NMC Cathodes.

Structure Evolution and Kinetics Study of Layered LiNixMnyCozO2 (x+y+z=1) Cathode Materials During Charge Using Synchrotron X-Ray Techniques

Probing Depth-Dependent Transition-Metal Redox of Lithium Nickel, Manganese, and Cobalt Oxides in Li-Ion Batteries

Surface Analysis of the Lithium-Rich Cathode Material Li1.2Mn0.54Co0.13Ni0.13NaxO2 by Advanced Electron Microscopy

Electrochemical Characteristics of Layered Transition Metal Oxide Cathode Materials for Lithium Ion Batteries: Surface, Bulk Behavior, and Thermal Properties

Transition-metal Redox Evolution and Its Effect on Thermal Stability of LiNi Co Mn O2 Based on Synchrotron Soft X-ray Absorption Spectroscopy

(Invited) Probing the in-Situ Surface Chemistry of Ni-Rich LiNi x Co y Mn z O2 (x+y+z=1) Cathode Materials Using Synchrotron-Based Ambient-Pressure X-Ray Photoelectron Spectroscopy

(Invited) Probing the in-Situ Surface Chemistry of Ni-Rich LiNi <sub>x</sub> Co <sub>y</sub> Mn <sub>z</sub> O<sub>2</sub> (x+y+z=1) Cathode Materials Using Synchrotron-Based Ambient-Pressure X-Ray Photoelectron Spectroscopy

Distinct Surface and Bulk Thermal Behaviors of LiNi0.6Mn0.2Co0.2O2 Cathode Materials As a Function of State of Charge.

Atomic scale evolution of the surface chemistry in Li[Ni,Mn,Co]O2 cathode for Li-ion batteries stored in air

The Role of Cobalt and Manganese for the Safety of Ni-Rich NMC Cathode

Valence study of and : The role of charge transfer and charge disproportionation