Abstract:Background: The rotor blades with fixed geometry in today's helicopters do not give the best performance throughout the duration of any mission. However, low-speed and high-speed flights have different geometrical requirements for the shape of the most efficient rotor blades. With advancements in morphing technologies, these can be applied to change the shape of the blades between different flight regimes. Methods: Two different helicopter rotor morphing concepts - namely, the linearly variable chord extension and the torque-tube based twist - under the framework of the European project SABRE were investigated for their optimal geometric parameters using a Particle Swarm Optimization (PSO) algorithm. Since the morphing parameters were dependent on the mission profile, three different missions representing typical helicopter applications were chosen. The optimization problem was posed both as single objective (power) and as multi-objective (power, tip elastic torsion and vibratory hub load). Based on the insights drawn from these investigations, a rotor was set up including both morphing concepts in a single blade. Results: The rotor with combined chord and twist morphing was shown to give performance improvement of 6.8% over the baseline blade for a whole mission while keeping the penalty on the elastic torsion and vibration of the rotor to a minimum. The performance improvement was higher at 13% for hover and low speed flight of µ = 0.14. Conclusions: Chord and twist are both important parameters determining the efficiency of a rotor blade. Since they have non-overlapping requirements, combining the two morphing concepts into a single blade can yield higher performance than the individual ones.

A Reformulated-Vortex-Particle-Method-Based Aerodynamic Multi-Objective Design Optimization Strategy for Proprotor in Hover and High-Altitude Cruise

Automated Design Optimization of a Mono Tiltrotor in Hovering and Cruising States

Hybrid Aerodynamic Optimization of a Propeller Based on the Reformulated Blade Element Momentum Theory

Blade Shape Optimization and Analysis of a Propeller for VTOL Based on an Inverse Method

Comprehensive Performance Optimization of Autonomous Underwater Helicopter Based on PSO

Flow Reconstructions and Aerodynamic Shape Optimization of Turbomachinery Blades by POD-based Hybrid Models

Particle Swarm Optimization of Aerodynamic Shapes with Nonuniform Shape Parameter–Based Radial Basis Function

Airfoil Parameterization Evaluation Based on a Modified PARASEC Method for a H-Darrious Rotor

Multiobjective Shape Optimization of A Hypersonic Lifting Body Using A Correlation-Based Transition Model

An rVPM-Based Aerodynamic Hybrid Optimization Method for Coaxial Rotor with Differentiated Upper and Lower Blades in Both Hover and High-Speed Cruising States

Multi-Objective Design Optimization of a Transonic Compressor Rotor Using an Adjoint Equation Method

Multidisciplinary Aerodynamic Design of a Rotor Blade for an Optimum Rotor Speed Helicopter

Rotor Cross-Tilt Optimization of Manned Multi-rotor Evtol Aircraft for Yaw Control Efficiency

Rapid Blade Shape Optimization for Contra-Rotating Propellers for eVTOL Aircraft Considering the Aerodynamic Interference

Large-Sized Multirotor Design: Accurate Modeling with Aerodynamics and Optimization for Rotor Tilt Angle

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

An Improved Multi-Objective Particle Swarm Optimization Method for Rotor Airfoil Design

Multiobjective optimization of a staggered-rotor octocopter design based on a surrogate model

Bi-layer sizing and design optimization method of propulsion system for electric vertical takeoff and landing aircraft

Tri-Rotor Propeller Design Concept, Optimization and Analysis of the Lift Efficiency During Hovering

Mission-based optimal morphing parameters for rotors with combined chord and twist morphing