Effect of particle shape on cyclic liquefaction resistance of granular materials

Sounik K. Banerjee,Ming Yang,Mahdi Taiebat
DOI: https://doi.org/10.1007/s11440-023-02169-9
2024-01-07
Acta Geotechnica
Abstract:This study adopts three-dimensional discrete element method to examine how particle shape affects the cyclic liquefaction resistance of granular materials. A family of superquadric particles is employed to model different particle shapes by varying two shape parameters: aspect ratio (AR) and blockiness ( B ). Five smooth and convex particle shapes are considered in this study, with AR ranging from 0.5 to 1.5, and B varying from 2 to 8. These particles are used to create isotropically compressed samples at an initial confinement of 100 kPa and two relative densities ( ) of and , resulting in ten samples. These samples are then subjected to constant-volume cyclic simple shearing with various levels of cyclic stress ratios until initial liquefaction occurs in 41 simulations. The results of these simulations reveal that at , the spherical particles exhibit the highest liquefaction resistance compared to the non-spherical particles. However, this trend is reversed for the samples with . By employing the overall regularity (OR) as a synthetic descriptor of particle shape, it is observed that liquefaction strength generally increases with higher OR at , while it demonstrates an approximately decreasing trend at . Furthermore, the initial coordination number and two critical state parameters based on the void ratio and the coordination number at the pre-shearing state of the samples, demonstrate a strong correlation with the cyclic liquefaction resistance within the ranges of particle shape and considered in this study.
engineering, geological
What problem does this paper attempt to address?