Abstract:Abstract Cellulose Nanofibrils (CNFs) was resulted from deconstruction of the hierarchical structure of cellulose. CNFs are commonly obtained by mechanical fibrillation, such as ultrafine grinding processes and its variation. Nevertheless, the influence of different treatments on the properties of the resulting CNF especially from variety of ultrafine grinding mode has not been reported. This study investigates the properties of cellulose nanofibrils (CNF) produced from bleached pulp oil palm empty fruit bunch (OPEFB) Kraft pulp through an ultrafine grinder with two different treatments in the fibrillation process. These two treatments were: 1) ultrafine grinder with increasing gaps distances; -30, -50, -70, and -90 μm with five cycles in every gap, 2) ultrafine grinder on constant gaps (-30μm) with increasing grinding cycles: 5, 10, 15, 30, and 40 cycles through the grinder. The influence of the treatment was evaluated through particle size distribution, crystallinity index, and morphological properties. The result showed that the increasing gaps treatment efficiently improved the size uniformity of CNFs, length 147-139.5 nm, and scanning electron microscope micrograph confirmed that the diameter of CNF was smaller with the increasing grinding gaps than increasing grinding cycles. However, the increasing cycle’s treatment produced CNF with a higher crystallinity index. The crystallinity index (CrI) of the CNF decreased from 71.27 to 62.25% with increasing gaps, whereas the CrI of the CNF from increasing cycles was 69.35%. This study provides a valuable guideline for determining the appropriate process to produce CNF especially by mechanical grinding using ultrafine grinder from OPEFB according to the desired result.

FRACTIONATION OF OLD CORRUGATED CONTAINERS FOR MANUFACTURE OF TEST LINER AND FLUTING PAPER

Interfacial Modiﬁcation and Dispersion of Short Carbon Fiber and the Properties of Composite Papers As Gas Diffusion Layer for Proton Exchange Membrane Fuel Cell (PEMFC)

Effects of AKD Sizing on the Morphology and Pore Distribution Properties of OCC Fibers

Effects of defibration process on the properties of old corrugated container fiber

Feasibility of substituting old corrugated carton pulp with thermal alkali and enzyme pretreated semichemical mechanical rice straw pulp

Pilot Enzymatic Treatment of Corrugating Medium

Production and characterization of pulp and paper from flax straw

Potential Use of Oil Palm Fronds for Papermaking and Application as Molded Pulp Trays for Fresh Product under Simulated Cold Chain Logistics

The Properties of OPEFB Cellulose Nanofibrils Produced by A Different Mode of Ultrafine Grinding

Utilizing Flax Straw for Sustainable Paper Production: Delignification Methods, Structural Analysis, and Fiber Size Distribution Effects

Producing Cellulose Microfibrils at a High Solid Content with and without Mechanical or Enzymatic Pretreatment

Structure analysis of three non-wood materials for liner paper

Potential use of nanofibrillated cellulose-loaded cationic starch solutions as coating formulation for recycled fluting papers

Enhancing the strength of tissue paper through pulp fractionation and stratified forming

Optimization of the Green Fibre Paper Film Preparation Process Based on Box–Behnken Response Surface Methodology

Influences of Drying Conditions on Sizing Performance of Recycled OCC Fibers

Effects of slushing process on the pore structure and crystallinity in old corrugated container cellulose fibre

Evaluating paper’s optical properties after separate and combined use of nanofibrillated cellulose with cationic starch and cationic polyacrylamide

Development of fibre properties in mill scale: high- and low consistency refining of thermomechanical pulp (part 2) – Importance of fibre curl

The effect of chemical composition on microfibrillar cellulose films from wood pulps: water interactions and physical properties for packaging applications

Structural, morphological, and thermal properties of cellulose nanofibers extracted from waste paper