Abstract:It is widely known that the miscibility between donor and acceptor is a crucial factor that affects the morphology and thus device performance of nonfullerene organic solar cells (OSCs). In this Letter, we show that incorporating a third component with lower miscibility and higher lowest unoccupied molecular orbital (LUMO) level into the state-of-the-art PM6:Y6 system can significantly enhance the performance of devices. The best results of the ternary devices are achieved by adding a small molecular acceptor named ITCPTC (∼5% w/w), which significantly improves the power conversion efficiency (PCE) of the host system from 16.44% to 17.42%. The higher LUMO of the third component increases the open-circuit voltage (VOC), while the low miscibility enlarges the domains and leads to improved short-circuit current density (JSC) and fill factor (FF). The efficacy of this strategy is supported by using other nonfullerene third components including an asymmetric small molecule (N7IT) and a polymer acceptor (PF2-DTC), which play the same role as ITCPTC and boost the PCEs to 16.96% and 17.04%, respectively. Our approach can be potentially applied to a wide range of OSC material systems and should facilitate the development of the OSC field.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsenergylett.0c01364?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsenergylett.0c01364</a>.Device fabrication and characterization, mobility test, AFM measurement, UV–vis absorption experiment, CV test, GIWAXS and GISAXS measurement, surface tension determination (<a class="ext-link" href="/doi/suppl/10.1021/acsenergylett.0c01364/suppl_file/nz0c01364_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Three‐in‐One Strategy Enables Single‐Component Organic Solar Cells with Record Efficiency and High Stability

Single-Component Organic Solar Cells with over 14% Efficiency

High‐Efficiency Ternary Organic Solar Cells Based on the Synergized Polymeric and Small‐Molecule Donors

A Simple Dithieno[3,2‐b:2′,3′‐d]pyrrol‐Rhodanine Molecular Third Component Enables Over 16.7% Efficiency and Stable Organic Solar Cells

High-performance organic solar cells enabled by the p-i-n structure and ternary strategy

Achieved 18.9% Efficiency by Fine‐Tuning Non‐Fullerene Acceptor Content to Simultaneously Increase the Short‐Circuit Current and Fill Factor of Organic Solar Cells

Efficient Dual Mechanisms Boost the Efficiency of Ternary Solar Cells with Two Compatible Polymer Donors to Exceed 19

Versatile third components for efficient and stable organic solar cells

Oligomer-Assisted Photoactive Layers Enable >18 % Efficiency of Organic Solar Cells

Simultaneous Improvements in Efficiency and Stability of Organic Solar Cells via a Symmetric‐Asymmetric Dual‐Acceptor Strategy

High-Efficiency Ternary Organic Solar Cells with a Good Figure-of-Merit Enabled by Two Low-Cost Donor Polymers

Non-fullerene acceptor fibrils enable efficient ternary organic solar cells with 16.6% efficiency

13% Single‐Component Organic Solar Cells based on Double‐Cable Conjugated Polymers with Pendent Y‐Series Acceptors

Adding a Third Component with Reduced Miscibility and Higher LUMO Level Enables Efficient Ternary Organic Solar Cells

Enhanced short circuit current density and efficiency of ternary organic solar cells by addition of a simple copolymer third component

Fine-tuning of film morphology through addition of a third component enables organic solar cells with efficiency over 18%

Polycyclic Aromatic Lactam‐like Donors Synthesized upon C−H Activation Strategy for High‐efficiency Ternary Organic Solar Cells

Achieving 12.6% Efficiency in Single‐Component Organic Solar Cells Processed from Nonhalogenated Solvents

Efficient Ternary Organic Solar Cells Enabled by the Integration of Nonfullerene and Fullerene Acceptors with a Broad Composition Tolerance

High‐Performance Small Molecule Organic Solar Cells Enabled by a Symmetric‐Asymmetric Alloy Acceptor with a Broad Composition Tolerance

Terpolymerization and Regioisomerization Strategy to Construct Efficient Terpolymer Donors Enabling High‐Performance Organic Solar Cells