Improvement in optoelectronics and photovoltaic properties of p-Co3O4/n-ZnO hetero-junction: effect of deposition time of sprayed Co3O4 thin films

Warda Darenfad,Noubeil Guermat,Nadir Bouarissa,Fatima Zohra Satour,Ameur Zegadi,Kamel Mirouh
DOI: https://doi.org/10.1007/s10854-023-11909-2
2024-01-18
Journal of Materials Science Materials in Electronics
Abstract:Spinel thin films Co 3 O 4 have been deposited at a temperature of approximately 400 °C using spray pyrolysis. The testimony process was carried out with different deposition times (4, 5, 6, and 8 min), indicating that the films were grown for varying durations. The objective of varying deposition times of the thin films of Co 3 O 4 was to optimize the fabrication of a hetero-junction between Co 3 O 4 and ZnO. XRD, SEM and Raman investigations showed that pure cubic Co 3 O 4 with an irregular spindle shaped particles have been successfully obtained. The films' thickness increased under prolonged preparation times leading to a denser surface. The optical measurements revealed that the thin layer with a deposition time of 8 min attained a total absorbance of 98% in the apparent spectrum with a band gap of 1.27 eV. The I–V characteristics recorded of FTO/ZnO/Co 3 O 4 /Au cells showed that all devices exhibiting a rectifying behavior with a perfect factor that varies between 3.87 and 1.64. Our results suggest that Co 3 O 4 at 8 min with a carrier density of 2.414 × 10 14 cm −3 and high absorbance is potentially a competitive hole transport material in spinel solar cells, and, the recorded characteristics of the photovoltaic phenomenon were noted a short circuit current of 1.302 mA, an open circuit voltage of 369 mV and a fill factor of 32%.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied
What problem does this paper attempt to address?