Abstract:The current research on secondary O-ring seals used in mechanical seals has begun to focus on their dynamic properties. However, detailed analysis of the dynamic properties of O-ring seals in spiral groove gas face seals is lacking. In particular a transient study and a difference analysis of steady-state and transient performance are imperative. In this paper, a case study is performed to gauge the effect of secondary O-ring seals on the dynamic behavior (steady-state performance and transient performance) of face seals. A numerical finite element method (FEM) model is developed for the dynamic analysis of spiral groove gas face seals with a flexibly mounted stator in the axial and angular modes. The rotor tilt angle, static stator tilt angle and O-ring damping are selected to investigate the effect of O-ring seals on face seals during stable running operation. The results show that the angular factor can be ignored to save time in the simulation under small damping or undamped conditions. However, large O-ring damping has an enormous effect on the angular phase difference of mated rings, affecting the steady-state performance of face seals and largely increasing the possibility of face contact that reduces the service life of face seals. A pressure drop fluctuation is carried out to analyze the effect of O-ring seals on the transient performance of face seals. The results show that face seals could remain stable without support stiffness and O-ring damping during normal stable operation but may enter a large-leakage state when confronting instantaneous fluctuations. The oscillation-amplitude shortening effect of O-ring damping on the axial mode is much greater than that on the angular modes and O-ring damping prefers to cater for axial motion at the cost of angular motion. This research proposes a detailed dynamic-property study of O-ring seals in spiral groove gas face seals, to assist in the design of face seals.

Investigation on transient response of gas face seals based on a double mass kinematic model considering Coulomb friction

Influence of separation, collision and friction of rotating ring in sleeve on vibration characteristics of gas face seals

Analysis of the Dynamic Friction of a Gas Face Seal Based on Acoustic Emissions

Stability and Tracking Analysis of Gas Face Seals under Low-Parameter Conditions Considering Slip Flow

Transient Thermoelastohydrodynamic Gas Lubrication of Face Seals

Influence Analysis of Secondary O-Ring Seals in Dynamic Behavior of Spiral Groove Gas Face Seals

Application of Fractal Contact Model in Dynamic Performance Analysis of Gas Face Seals

Transient Response Analysis of Spiral Groove Gas Face Seals under Pressure-drop Fluctuation

Semi-Analytical Dynamic Analysis of Noncontacting Finger Seals

Transient Response and Rub-Impact Phenomenon of Liquid Lubricated Non-Contacting Mechanical Seals During External Pressure Fluctuation

Numerical Modeling of Dynamic Sealing Behaviors of Spiral Groove Gas Face Seals

Dynamic Response Analysis to Seal Chamber Pressure Perturbation of a New Double Spiral Groove Face Seal

Numerical Analysis of the Traction Effect on Reciprocating Seals in the Hydraulic Actuator

Influence of Inlet Pressure Disturbance on Transient Performance of Liquid Oxygen Lubricated Mechanical Seal and Rub-Impact Phenomenon Caused by Excitation Overload

Analysis of Thermoelastic Contact of Gas-Lubricated Rough Sealing Faces

A Closed-Form Contact Model for Gas Face Seals During the Opened Operation

Numerical Analysis of Deformation of a Non-Contacting Gas Lubricated Seal

Research Progress on the Dynamic Stability of Dry Gas Seals

Dynamic Leakage Analysis of Noncontacting Finger Seals Based on Dynamic Model

Analysis of friction vibration characteristics of the end face of a T-slot sealing ring under thermal deformation

Applicability Analysis of Steady-state Models for Spiral Groove Gas Face Seals