Abstract:Adding hydrogen to the intake of a diesel engine offers a near-term route to reducing greenhouse gas emissions from heavy-duty commercial vehicles. Variations in combustion behavior between cylinders can limit the performance and H 2 utilization in these engines. This research evaluates the impacts of varying H 2 concentrations between cylinders due to the phasing of pulsed fuel injection in the intake manifold, and the potential to optimize the diesel injection strategy for each cylinder to compensate for these effects. The study is conducted using a predictive phenomenological combustion model for H 2 -diesel combustion within the GT-SUITETM software environment calibrated and validated using experimental data from a 4-cylinder, 5.2 L engine at three loads and at two different H 2 concentrations per load. Predictions of engine and combustion performance were within 5% of the experimental results for key parameters. The validated model is then used to quantify the impacts of varying H 2 distribution between cylinders on combustion performance and hardware limitations including peak cylinder pressure, rate of pressure rise, and exhaust temperature. From these results, the diesel injection parameters, including timing and quantity of both pilot and main injections, are optimized for each cylinder to minimize variations in engine performance. The results indicate that cylinder-to-cylinder variations in H 2 concentration increased with more rapid H 2 injection, due to limited dispersion of H 2 between the cylinders. Variations in indicated power approached 13.5% between cylinders, with those with high H 2 content encountering a substantial risk of knock and noise. Adjusting the diesel injected mass per cylinder balanced power variations, while adjusting pilot injection timing minimized variations in the rate of pressure rise (dP/dCA). Exhaust temperature and efficiency were most sensitive to the timing of the main diesel injection. Combined, these control approaches reduced diesel fuel consumption and CO 2 emission by 5.2 and 6.2%, respectively, where an average 3.8% increase in the engine's indicated efficiency was observed. The optimization findings offer a promising approach for balancing the engine performance when there is unbalanced H 2 distribution between the cylinders.

Influences of hydrogen addition from different dual‐fuel modes on engine behaviors

Combustion, performance and emission analyses of a CI engine operating with renewable diesel fuels (HVO/FARNESANE) under dual-fuel mode through hydrogen port injection

An experimental investigation of effect on diesel engine performance and exhaust emissions of addition at dual fuel mode of hydrogen

Effect of hydrogen–diesel dual-fuel usage on performance, emissions and diesel combustion in diesel engines

Influence of hydrogen injection timing and duration on the combustion and emission characteristics of a diesel engine operating on dual fuel mode using biodiesel of dairy scum oil and producer gas

Experimental Analysis of Hydrogen Addition at Varying Injection Opening Pressures on a Dual-Fuel Diesel Engine Operating with Diesel and Cottonseed Oil

Experimental investigation of the effect of hydrogen ratio on engine performance and emissions in a compression ignition single cylinder engine with electronically controlled hydrogen-diesel dual fuel system

Role of the Compression Ratio in Dual-Fuel Compression Ignition Combustion with Hydrogen and Methanol

The effect of using hydrogen at partial load in a diesel-natural gas dual fuel engine

Analysis of CRDI diesel engine characteristics operated on dual fuel mode fueled with biodiesel-hydrogen enriched producer gas under the single and multi-injection scheme

Impact of hydrogen induction on atomization combustion performance and emissions in diesel engines fueled with heated biodiesel blends

Computational Investigation of Combustion, Performance, and Emissions of a Diesel-Hydrogen Dual-Fuel Engine

Computational study of hydrogen engine combustion strategies: Dual-Fuel compression ignition with Port- and Direct-Injection, Pre-Chamber Combustion, and Spark-Ignition

Experimental Study on the Effects of Hydrogen Injection Strategy on the Combustion and Emissions of a Hydrogen/Gasoline Dual Fuel SI Engine under Lean Burn Condition

Hydrogen-diesel dual-fuel combustion sensitivity to fuel injection parameters in a multi-cylinder compression-ignition engine

Investigation of the effects of hydrogen energy ratio and valve lift amount on performance and emissions in a hydrogen-diesel dual-fuel compression ignition engine

Numerical Investigation on the Effects of Load Conditions and Hydrogen-Air Ratio on the Combustion Processes of a HSDI Engine

Computational comparison of the conventional diesel and hydrogen direct-injection compression-ignition combustion engines

Effects of hydrogen addition in intake air on combustion and emission of diesel engines

Experimental Investigation in Optimizing the Hydrogen Fuel on a Hydrogen Diesel Dual-Fuel Engine

Exploring Hydrogen–Diesel Dual Fuel Combustion in a Light-Duty Engine: A Numerical Investigation