Hydrogen-diesel dual-fuel combustion sensitivity to fuel injection parameters in a multi-cylinder compression-ignition engine

Reza Farzam,Gordon McTaggart-Cowan

DOI: https://doi.org/10.1016/j.ijhydene.2023.09.124

IF: 7.2

2023-10-03

International Journal of Hydrogen Energy

Abstract:Adding hydrogen to the intake of a diesel engine offers a near-term route to reducing greenhouse gas emissions from heavy-duty commercial vehicles. Variations in combustion behavior between cylinders can limit the performance and H 2 utilization in these engines. This research evaluates the impacts of varying H 2 concentrations between cylinders due to the phasing of pulsed fuel injection in the intake manifold, and the potential to optimize the diesel injection strategy for each cylinder to compensate for these effects. The study is conducted using a predictive phenomenological combustion model for H 2 -diesel combustion within the GT-SUITETM software environment calibrated and validated using experimental data from a 4-cylinder, 5.2 L engine at three loads and at two different H 2 concentrations per load. Predictions of engine and combustion performance were within 5% of the experimental results for key parameters. The validated model is then used to quantify the impacts of varying H 2 distribution between cylinders on combustion performance and hardware limitations including peak cylinder pressure, rate of pressure rise, and exhaust temperature. From these results, the diesel injection parameters, including timing and quantity of both pilot and main injections, are optimized for each cylinder to minimize variations in engine performance. The results indicate that cylinder-to-cylinder variations in H 2 concentration increased with more rapid H 2 injection, due to limited dispersion of H 2 between the cylinders. Variations in indicated power approached 13.5% between cylinders, with those with high H 2 content encountering a substantial risk of knock and noise. Adjusting the diesel injected mass per cylinder balanced power variations, while adjusting pilot injection timing minimized variations in the rate of pressure rise (dP/dCA). Exhaust temperature and efficiency were most sensitive to the timing of the main diesel injection. Combined, these control approaches reduced diesel fuel consumption and CO 2 emission by 5.2 and 6.2%, respectively, where an average 3.8% increase in the engine's indicated efficiency was observed. The optimization findings offer a promising approach for balancing the engine performance when there is unbalanced H 2 distribution between the cylinders.

energy & fuels,electrochemistry,chemistry, physical