Abstract:To obtain fine and disordered precipitated phases and coordinate multiple strengthening mechanisms in face -centered cubic (FCC) high entropy alloys (HEAs), the Co30Cr30Fe17Ni17Mo6 HEA was prepared and annealed at various temperatures (800, 1000, and 1200 degrees C for 2 h, furnace cooling). The phase stability, microstructure evolution, and tensile properties were systematically investigated at room and low temperatures. The as-cast alloy is consisted of the FCC phase and primary sigma phase rich (Cr, Mo) element. The as-annealed alloy pre-cipitates a fine and disordered secondary sigma phase from the FCC matrix around the primary sigma phase. The average areal size of the secondary sigma phase gradually increases from 1.848 mu m2 to 2.307 mu m2 with the increase of as -annealed temperature. The highest Gibbs free energy of the FCC phase in thermodynamic and the sluggish diffusion kinetics of elements induce the fine and disordered secondary sigma phase precipitation. The as-annealed HEA has a high yield strength of 557 MPa at A800, increased by 21% compared with the as-cast alloy, and maintains applicable plasticity of 16.91% at 298 K. The as-annealed HEA at A1000 exhibits strength-ductility synergy at 203 K. The high yield strength is attributed to secondary sigma phase strengthening and sigma/FCC inter-face strengthening coordination. Dislocations accumulate and strongly interact at the sigma/FCC interfaces, which induces the formation of back stress in softer matrix phases. The back stress and dislocation cells provide the hardening of the FCC matrix at 298 K. The back stress, the net dislocations, and stack faults are activated in the FCC matrix phase to induce high strain hardening ability at 203 K. The FCC matrix with high strain hardening ability reduces stress concentration and delays crack initiation. The strain gradients are accumulated in the FCC matrix, secondary sigma phase, and primary sigma phase to realize strength-ductility synergy.

Structure-Phase Status of the High-Entropy AlNiNbTiCo Alloy

Study on Precipitation in (cocrfemnni)90al6ti4 High Entropy Alloy

Phase Stability of AlCoTiZn High-Entropy Alloy Prepared by Mechanical Alloying

Microstructure and Properties of NiCoCrAlTi High Entropy Alloy Prepared Using MA-SPS Technique

Evolution of the Structure and Phase Composition of a High-Entropic CoCrFeNiCu Alloy during Prolong Annealing

Evolution of the phase structure after different heat treatments in NiCoFeCrGa high entropy alloy

Structure and Stability of High Entropy CrMnFeCoNiCu Alloy

A Study of the Structure and Mechanical Properties of Nb-Mo-Co-X (X = Hf, Zr, Ti) Refractory High-Entropy Alloys

Microstructure Evolution and Strengthening Mechanisms in Ni36Co30Cr11Fe11Al12-Nb High Entropy Alloys

The phase stability at intermediate-temperature and mechanical behavior of the dual-phase AlCoCr0.5FexNi2.5 high entropy alloys

Phase stability and strengthening behavior of as-annealed Co30Cr30Fe17Ni17Mo6 high entropy alloy at room and low temperatures

Microstructure characterization and phase evolution of equiatomic AlCoMoFeNi high entropy alloy synthesized by mechanical alloying

On the Solidification and Phase Stability of a Co-Cr-Fe-Ni-Ti High-Entropy Alloy

Microstructural Study of CrNiCoFeMn High Entropy Alloy Obtained by Selective Laser Melting

Microstructure evolution and mechanical properties of directionally solidified Ni36Co30Fe11Cr11Al8Nb4 high entropy alloy

Phase Stability and Microstructural Evolution in a Ductile Refractory High Entropy Alloy Al 10 Nb 15 Ta 5 Ti 30 Zr 40

Microstructure and mechanical properties of Al-Fe-Co-Cr-Ni high entropy alloy fabricated via powder extrusion

Alloy Design and Properties Optimization of High-Entropy Alloys

Introducing a new heterogeneous nanocomposite thin film with superior mechanical properties and thermal stability

Secondary Phases in AlxCoCrFeNi High-Entropy Alloys: an In-Situ TEM Heating Study and Thermodynamic Appraisal

Microstructure and Strengthening Mechanisms in Multi-Phase Ni36co30cr11fe11al12-Xtax High Entropy Alloy