Abstract:Lithium iron silicate (Li2FeSiO4) has high theoretical capacity of 332 mAh∙g−1 upon full extraction of two lithium ions, which is accompanied by high delithiation potential and large volume change. Sulfur modification could be an effective approach for stabilizing Li2FeSiO4 cathodes. A series of carbon-coated Li2FeSiO4 samples were prepared through a hydrothermal and solid-state reaction route at a fixed sucrose content (14 wt% carbon) with varying amounts of sublimed sulfur at 5, 10, 15, 20 and 25 at%. The crystal structures, chemical compositions, microstructures and electrochemical performances of the differently sulfur-modified Li2FeSiO4/C were systematically investigated. The sulfur-carbon co-modifications and possible existing chemical states of sulfur are discussed in terms of the surface and near-bulk modifications. It was found that all the samples exhibited a monoclinic P21 structural Li2FeSiO4, while the sulfur contents over 10 at% formed impure phases such as iron sulfides (Fe1-xS) and lithium metasilicate (Li2SiO3). Furthermore, three types of sulfur states could be found when sulfur and carbon were added simultaneously into Li2FeSiO4. The surfaces were predominated by S–C and S–O–C, indicating the sulfur-carbon co-modification, which would reduce the resistance at the solid/electrode interface (SEI) but increase the charge transfer resistance. Near the bulk, the enhanced interactions between sulfur and iron S–Fe(−S) or sulfur and silicon S–Si(−O) may lead to the formation of possible impurities or oxygen substitution by sulfur. The former is detrimental as the effective sulfur amount is reduced, while the latter is beneficial to improve specific capacity and cycle stability. The overall performance of sulfur-carbon co-modified sample is influenced complicatedly by the sulfur content. The best initial discharge capacity of 152.3 mAh∙g−1 was obtained with 5 at% sulfur modification, while the best overall performance, showing a typical warm-up response and good cycle stability, was observed with 15 at% sulfur modification.

Carbon doping endows silicon oxide with enhanced redox kinetics of polysulfides

In Situ Synthesis of Carbon Doped Porous Silicon Nanocomposites As High-Performance Anodes for Lithium-Ion Batteries.

Carbon Dot-Modified Silicon Nanoparticles for Lithium-Ion Batteries

Cobalt-Doping of Molybdenum Disulfide for Enhanced Catalytic Polysulfide Conversion in Lithium-Sulfur Batteries

Electrocatalysis Of S-Doped Carbon With Weak Polysulfide Adsorption Enhances Lithium-Sulfur Battery Performance

Metal-doped Mesoporous Silica As Sulfur Hosts in Lithium‑sulfur Battery with Enhanced Conductivity and Polysulfide Adsorption Ability

Co/CoS2 Heterojunction Embedded in N, S‐Doped Hollow Nanocage for Enhanced Polysulfides Conversion in High‐Performance Lithium–Sulfur Batteries

Oxidation States Regulation of Cobalt Active Sites through Crystal Surface Engineering for Enhanced Polysulfide Conversion in Lithium–Sulfur Batteries

CoS2@C catalyzes polysulfide conversion to promote rate and cycling performances of lithium—sulfur batteries

MOF-Derived CoS2/N-Doped Carbon Composite to Induce Short-Chain Sulfur Molecule Generation for Enhanced Sodium-Sulfur Battery Performance

Tuning of d-p band centers with M-A (M = Co, Ni, Cu; A = N, P, O, Se) co-doped FeS 2 for enhanced Li-S redox chemistry

Manipulating the Conversion Kinetics of Polysulfides by Engineering Oxygen p‐Band of Halloysite for Improved Li‐S Batteries

Dual regulation of polysulfides redox kinetics and lithium deposition with ultrafine Co–Mo 2 C nanocrystals confined in 2D nitrogen-doped carbon sheets for Li–S batteries

Effective disproportionation of SiO induced by Na2CO3 and improved cycling stability via PDA-based carbon coating as anode materials for Li-ion batteries

Mechanistic study in sulfur-carbon co-modification on Li2FeSiO4 for lithium-ion batteries

Activating Redox Kinetics of Li2S via Cu+, I- Co-Doping Toward High-Performance All-Solid-State Lithium Sulfide-Based Batteries

Oxygen Doping in Antimony Sulfide Nanosheets to Facilitate Catalytic Conversion of Polysulfides for Lithium-Sulfur Batteries.

A thick titanium dioxide layer formed by Co-doping on a carbon surface promotes the polysulfide-adsorption ability in Li–S batteries

A Porous Hexagonal Prism Shaped C-In2-XCoXO3 Electrocatalyst to Expedite Bidirectional Polysulfide Redox in Li-S Batteries

An Electron-Coupled Co-ZrO2 Nanodot Heterojunction Electrocatalyst with Lewis Acid-Base Site Pairs Enables High Redox Reaction Kinetics of Li-S Batteries

Promoting sulphur conversion chemistry with tri-modal porous N, O-codoped carbon for stable Li–S batteries