Experimental investigation on battery thermal management strategy applying water retention material

Chun Wang,Zijie Ren,Huan Xi

DOI: https://doi.org/10.1016/j.est.2023.110191

IF: 9.4

2024-01-03

Journal of Energy Storage

Abstract:The thermal issue of the quantities of electronics especially batteries during practical application has always been a big concern. To better satisfy their heat dissipation demands in engineering application , a novel half-passive strategy applying water retention material was proposed in this research. The thermal management assembly containing silica pad, copper foam and water-diatomite mixture is attached on the surface of the constant heating source. Primarily, the effectiveness of the assembly was validated through comparative experiments , which turned out to lengthen the effective time by 125.6 %. Then, the effects of both internal and external control parameters including ambient environment, heating power, properties of the water-diatomite mixture, PPI (pores per linear inch) of the copper foam and mesh number of the diatomite were discussed on the heat dissipation ability evaluated by the maximum temperature ( T max ) and effective time ( t ). At last, the cooling performance with different intermittent spray mode of the assembly during longtime operation was investigated. Results showed that when heated with 11.0 W, the spray began at 45 °C and the intervals were set as 5 min, 7.5 min, 10 min with the water content in each spray of 3.0 g, 4.0 g, 5.0 g respectively were the most reasonable schemes, and the CF-D (copper foam-diatomite) assembly managed to control the maximum temperature around 46.0 °C. This novel design provides a practical reference for the further optimization on the battery thermal management system, which focused more on the cooling efficiency and control flexibility.

energy & fuels