Abstract:The effect of Cr segregation on the mechanical behavior and deformation mechanism of Ni‐Co‐Cr alloy is studied by MD. It is found that the introduction of solute atoms provides strong support for grain boundries, and the barrier of grain boundries makes it difficult for dislocation sources to activate in adjacent grains. Ni─Co alloys have attracted extensive attention from materials researchers in recent years because of their excellent properties. The effect of solute segregation on the properties of the alloy is studied by molecular dynamics simulation. The results show that the yield strength increases from 2.8 to 3.5 GPa when the solute atom Cr is introduced into the grain boundary. Under the action of stress, the disorder of segregation grain boundary is enhanced, which hinders the growth of grain, produces less layer fault structure, and the peak number of HCP (Hexagonal Close Packed) atom decreases from 50 000 to 37 000. The introduction of solute atoms provides a strong support for the grain boundary and has a similar skeleton structure, which improves the deformation resistance of the lattice. In addition, the improved grain boundary stability leads to the difficulty of nucleation of the dislocation, because the obstruction of the grain boundary makes it difficult to activate the dislocation source in the adjacent grain, and the maximum reduction of the perfect dislocation is 74%. In general, the microscopic mechanism of solute segregation strengthening is discussed from dislocation, phase structure, and energy, which provides guidance for plastic deformation of solid‐solution alloys.

Effect of dislocation configuration on Ag segregation in subgrain boundary of a Mg-Ag alloy

Experimental Characterization and First-Principles Calculations of Zn Segregation at the Β″-Mg5al2si4/al Interfaces in Al-Mg-Si Alloys

Effect of Cu and Mg co-segregation on the strength of the Al grain boundaries: A molecular dynamics simulation

First-principles investigation of the Mg, Cu segregation at Al Σ5 (310) and Σ9 (221) symmetrical tilt grain boundaries

Periodic linear complexions: Co-segregation of solutes at a low-angle grain boundary in a magnesium alloy

Grain boundary and twin boundary solute segregations in nanocrystalline Al-Mg alloy

Dislocation-induced Y segregation at basal-prismatic interfaces in Mg

Effect of grain boundary character on segregation-induced structural transitions

Interfacial Segregation and Precipitates Behavior in the Ultrafine Grained Al-based Metal Matrix Composites

High-throughput first-principles investigation on grain boundary segregation of alloying elements in ferritic steel

Effect of dynamic recrystallization, LPSO phase, and grain boundary segregation on heterogeneous bimodal microstructure in Mg-9.8Gd-3.5Y-2.0Zn-0.4Zr alloy

Effect of solute atoms segregation on Al grain boundary properties by First-principles study

Grain boundary energy effect on grain boundary segregation in an equiatomic high-entropy alloy

Effect of Cr Segregation on Mechanical Behavior and Deformation Mechanism of Ni─Co─Cr Alloy

Effect of solute atoms segregation on Al grain boundary energy and mechanical properties by first-principles study

Atomic simulations of the effect of Y and Al segregation on the boundary characteristics of a double twin in Mg

Atomistic Study of Grain-Boundary Segregation and Grain-Boundary Diffusion in Al-Mg Alloys

Simulation Study on the Nano-Crystalline Cu-Ag Alloys with Gradient Segregation

Effect of Mo on Segregation Behavior of Al-Mg-Si-Mn Alloy Produced by Twin-Roll Casting

Co-segregation of Mg and Zn atoms at the planar η1-precipitate/Al matrix interface in an aged Al–Zn–Mg alloy

Probing the Effect of Alloying Elements on the Interfacial Segregation Behavior and Electronic Properties of Mg/Ti Interface via First-Principles Calculations