Abstract:This study deals with the Nb–niobium silicide-based composites developed by the hot-pressing of Nb–Si–Ti ternary powder mixtures with a fixed Ti addition (6at.%) and Si content ranging from hypereutectic (11at.%) to near-eutectic compositions (18at.%). The effects of Si content, Ti addition and strain rates on the sample microstructural characterization, flexural strength, fracture toughness, quasi-static compressive deformation and failure processes were investigated. It was revealed that the volume fraction of silicides increased with increasing Si content, and most of the Ti atoms dissolved into the niobium silicides to form (Nb,Ti)5Si3 solid solutions instead of binary titanium silicides. The experimental evidence showed that a moderate improvement in the flexural strength, fracture toughness and compressive yield stress of the composites was achieved by the addition of Ti. Higher Si additions produced a much more remarkable enhancement in the compressive yield stress and bulk hardness, whereas both the flexural strength and fracture toughness decreased with increasing Si content owing to the existence of residual porosities in the samples. The composites showed remarkable superiority to the arc-melted Nb–Si alloys and monolithic niobium silicides in fracture toughness (8.3–13.0MPam vs. 4.5MPam), where the toughening effect was attributed mainly to crack bridging and crack deflection by the remaining ductile Nb phase. Moreover, quasi-static uniaxial compression tests at strain rates between 10–5 and 10–3s−1 indicated that the deformation behavior and failure processes were significantly affected by Si content and strain rates. The strain-rate-hardening behavior for all the strain rates was observed in the composite materials and the strain-rate sensitivity decreased with increasing Si content. At a lower strain rate, the composite materials with a hypoeutectic Si composition failed with a pseudoplastic response and at an angle of ∼45° off the compressive loading direction. However, in the case of higher strain rate and Si content, the brittle failure in the samples occurred through vertical splitting and spalling of fragments.

Strength-ductility synergy of element Ru for Nb–Si based in-situ composites

The Effects of Key Elements Re and Ru on the Phase Morphologies and Microstructure in Ni-based Single Crystal Superalloys

Strengthening enhanced by Ru partitioned to γ' phases in advanced Nickel-based single crystal superalloys

Homogenizing Effects of Co on Multi-Scale Elemental Distribution in Ru-containing Ni-based Single Crystal Superalloys

The potential application of Ru in aluminide coatings with reduced Al contents: A combined experimental and theoretical study

Effects of Re and Ru on the Solidification Characteristics of Nickel-Base Single-Crystal Superalloys

The Effect of Ru on the Evolution of the γ' Phase in Ni-Al-Ru Alloys

Effect of Co on microstructures and mechanical properties for Nb-Si based in-situ composites

Synergistic Effect of Rhenium and Ruthenium in Nickel-Based Single-Crystal Superalloys

Microstructure and Phase Equilibria in BCC-B2 Nb-Ti-Ru Refractory Superalloys

Insight into the mechanical, thermodynamics and superconductor properties of NbRuB via first-principles calculation

Microstructure and mechanical properties of Nb 16Si alloys with Zr additions

Behaviors and interactions of strengthening and constraint for ductile Nbss matrix in Nb–Si based alloys

Influence of Ru on the thermomechanical fatigue deformation behavior of a single crystal superalloy

Microstructural and mechanical characterization of Nb-based in situ composites from Nb–Si–Ti ternary system

Mechanical properties and microstructure evolution of NbSiZr based alloy

A Study of the Effects of Hf and Sn on the Microstructure, Hardness and Oxidation of Nb-18Si Silicide-Based Alloys-RM(Nb)ICs with Ti Addition and Comparison with Refractory Complex Concentrated Alloys (RCCAs)

On the effect of Ru upon creep behaviour and dislocation evolution in Ni-based single crystal superalloys

The widening of the solution heat treatment window by the addition of Ru in Ni-based single crystal superalloy

New insights into effects of Ru on the oxidation behaviour of Ni-based single-crystal superalloys at 1150 °C

Site preference and effect on shear deformation of co-alloying elements addition to γ′-Ni3Al phase in Ni-based single crystal superalloys