Abstract:Dual-comb spectroscopy typically requires the utilization of two independent and phase-locked femtosecond lasers, resulting in a complex and expensive system that hinders its industrial applications. Single-cavity dual-comb lasers are considered as one of the primary solution to simplify the system. However, controlling the crucial parameter of difference in repetition rates remains challenging. In this study, we present a dual-comb mode-locked Yb:CALGO laser based on a cavity-shared configuration with separated end mirrors. We employ two pairs of end mirrors and two thin-film polarizers angled at 45 degrees to the cavity axis, leading to separating the cross-polarized laser modes. We achieve simultaneous operation of two combs at approximately 1040 nm with pulse durations of around 400 fs and an average power exceeding 1 W. The repetition rates are approximately 59 MHz and their difference can be easily tuned from zero up to the MHz range. By effectively canceling out common mode noises, we observe minimal fluctuation in the repetition rate difference with a standard deviation of about 1.9 Hz over ten minutes, while experiencing fluctuations in repetition rates as large as 90 Hz. We demonstrate the capabilities of this system by utilizing the free-running dual-comb setup for asynchronous optical sampling on a saturable absorber and measuring etalon transmission spectrum. This system allows for simple and independent control of the repetition rates and their difference during operation, facilitating the selection of optimal repetition rate difference and implementation of phase-locking loops. This advancement paves the way for the development of simple yet high-performance dual-comb laser sources.

Bi-Directional Mode-Locked Thulium Fiber Laser as a Single-Cavity Dual-Comb Source

Dual-comb mode-locked Yb:CALGO laser based on cavity-shared configuration with separated end mirrors

Spectral overlapping single-cavity dual-comb fiber laser with well-controlled repetition rate difference

1.9–2.4 μm Tunable Dual-Comb From a Polarization-Maintaining Single-Cavity Bidirectional Fiber Laser

Dual-wavelength Mode-Locked Thulium-Doped Fiber Laser Based on Carbon Nanotube

1.9m Tunable Dual-Comb From a Polarization-Maintaining Single-Cavity Bidirectional Fiber Laser

Coherent Dual-Comb Mode-locked Fiber Laser based on a Birefringent Ring Cavity

Unidirectional, dual-comb lasing under multiple pulse formation mechanisms in a passively mode-locked fiber ring laser

Dual-Comb Spectroscopy Using a Hybrid Mode-Locked Fiber Laser

Fast Dual-Comb Spectroscopy Based on a Dual-Wavelength All-Fiber Ring Laser with High Repetition Rate

Wavelength-Switchable 2 μm Single-Longitudinal-Mode Thulium-Doped Fiber Laser Based on Dual-Active Cavity and DLTCTR

Mode-resolved Dual-Comb Spectroscopy with a Free-Running Polarization-Maintain Fiber Laser Cavity

A dual-wavelength and dual-repetition-rate actively mode-locked fiber ring laser

Switchable Dual-Wavelength Mode-Locking of Thulium-Doped Fiber Laser Based on SWNTs

Single-Cavity Dual-Comb Yb:YAG Laser Operating at 250 MHz with Ultra-Low Noise

Single Longitudinal Mode Narrow Linewidth Thulium-Doped Fiber Laser Based on a Eye-Shaped Dual-Ring Filter

Bandwidth Tunable, Dispersion-managed Mode-locked Thulium/holmium Fiber Laser

Dual-dispersion-regime dual-comb mode-locked laser

20 GHz Actively Mode-Locked Thulium Fiber Laser.

Polarization-multiplexed, single-cavity dual-comb fiber laser based on a birefringent crystal and a saturable absorber.

Single-cavity Bidirectional Raman-assisted Mode-Locked Fiber Laser