Abstract:The development of molten salt reactors (MSRs) is a collaborative effort among academia, government laboratories, and industry, with the aim of realizing the potential of clean nuclear energy. However, the corrosion of structural alloys presents a significant engineering challenge in this application. Addressing this issue requires investment not only in testing and characterizing candidate alloys, but also in developing a scientific framework to understand the fundamental mechanisms governing the corrosion of metallic materials in molten fluorides which can then guide alloy design [1]. In this work, the corrosion behavior of binary Ni-Cr alloys (5-20 wt.% Cr) in molten LiF-NaF-KF (or FLiNaK) salts between 550 o C and 750 o C was interrogated using electrochemical methods coupled with thermo-kinetic analysis. Electrochemical techniques, including linear sweep voltammetry, electrochemical impedance spectroscopy (EIS) and chronoamperometry, were utilized to elucidate the rate-limiting kinetic factors and to identify the dependence of corrosion morphology on applied potential. Additionally, Ni-Cr alloys were also immersed 99.9% pure FLiNaK salts with a known oxidizer concentration (e.g., 0.1-5 wt.% EuF 3 ) coupled with open-circuit potential measurement to provide a time-based description of morphological evolution in the case of a dynamically changing electrode potential. These results are corroborated by examination of the post-corrosion morphology using scanning electron microscopy (SEM), transmission electron microscopy (TEM), and electron backscatter diffraction (EBSD) techniques as well as salt composition analysis using inductively coupled plasma mass spectrometry (ICP-MS), X-ray diffraction (XRD) and in situ cyclic voltammetry. The systematic choice of potential revealed multiple potential regimes in which Ni-Cr alloys exhibit distinctly different corrosion morphologies. At intermediate potentials, a porous bicontinuous structure is formed by dealloying of the less noble element (Cr) and percolation into the Ni-rich alloy within grains and along grain boundaries. At other potentials, charge transfer control dissolution of both Cr and Ni leads to the formation of a crystallographic faceted structure. The morphological differences suggest the presence of multiple corrosion processes in Ni-Cr in FLiNaK controlled by either transport or interfacial reaction. These findings can be explained through electrochemical processes at the alloy-salt interface, as well as the roles of surface, grain boundary and bulk diffusion kinetics involving the alloying constituents. Furthermore, the effect of radiation damage on Ni20Cr alloys on these rate-limiting corrosion regimes will be investigated. Acknowledgment Research is primarily supported as part of the fundamental understanding of transport under reactor extremes (FUTURE), an Energy Frontier Research Center (EFRC) funded by the U.S. Department of Energy (DOE), Office of Science, Basic Energy Sciences (BES). [1] Chan, H.L., et al. Npj Materials Degradation 6(1), 46 (2022).

Corrosion behaviour of AlN ceramics in LiF-LiCl-LiBr-Li molten salt at 500 °C

Corrosion behavior and failure mechanism of amorphous Al2O3 coating at high-temperature LBE

Corrosion of Two Iron-Based Aluminaforming Alloys in NaCl-MgCl2 Molten Salts at 600 °C

Understanding High-Temperature Corrosion Behavior of an AlN/Mo Functionally Graded Material Exposed to Li/LiF-LiCl-LiBr Vapor

Corrosion Behavior of Ni-Cr Alloys with Different Cr Contents in NaCl-KCl-MgCl2

Corrosion behavior of a wear resistant Co-Mo-Cr-Si alloy in molten fluoride salts

Corrosion Behavior of the GH3535 and C276 Alloys at the Liquid/Gas LiCl–KCl Salt Interface at 550 °C

The inhibition of the interaction between CVD SiC and GH3535 alloy in molten LiF-NaF-KF salt by the Li metal

Corrosion Behavior of Binary Ni-Cr Alloys in Molten FLiNaK Salts at Different Electrochemical Potentials

Ni/AlN Composite Coating for Corrosion and Elements Interdiffusion Resistance in Molten Fluoride Salts System

Corrosion behaviour and related mechanism of lithium vapour on aluminium nitride ceramic

Electrochemical impedance study of corrosion of pure Ni, Fe, Cr, and Fe‐5Cr alloy in molten nitrides

Metallic impurities induced corrosion of a Ni-26W-6Cr alloy in molten fluoride salts at 850 oC

Corrosion behavior of iron-based and Ni-based alloys melted in NaCl–MgCl 2 –KCl mixed molten salt under vacuum atmosphere

Corrosion of 316L Stainless Steel Alloy and Hastelloy-N Superalloy in Molten Eutectic LiF-NaF-KF Salt and Interaction with Graphite

Corrosion Behavior of Nitrogen-Containing Low-Nickel Weld Cladding in KCl-MgCl2 Eutectic Molten Salt at 900 °C

Corrosion Behavior of 20G and TP347H in Molten LiCl-NaCl-KCl Salt

Corrosion behavior of UNS N10003 alloy in molten LiF-BeF2-ZrF4 with phosphide impurity

Effect of YAl₂ Particles on the Corrosion Behavior of Mg⁻Li Matrix Composite in NaCl Solution

Feasibility Study on Aluminum Under Laser Ablation for Corrosion Resistance in Molten Salt

Corrosion of Refractory Alloys in Molten Lithium and Lithium Chloride