Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. In this study, a novel TCU control structure and algorithms including also dynamic model of the transmission will perform the gear shifting of automatic transmissions used in tracked military vehicles are designed. In case of inherent wear of the clutches, the clutch parameters are estimated by means of an adaptation algorithm that uses only the information from the transmission input and output speed sensors. These estimated clutch parameters are used in clutch torque calculation is utilized by control algorithms. For the clutch speed control in the inertia phase, a PID control structure with a negative feedforward term that cancels the nonlinearities of the system is proposed. The feedforward term utilizes the estimated wear clutch coefficients in the calculation of friction coefficients. The parameters of the PID controller are optimized by a genetic algorithm. The designed all structure are firstly tested on a MATLAB/Simulink power train simulation model, and then tested using a unique transmission on a transmission dynamometer test bench to examine its suitability for real transmission scenarios. The performances of proposed PID control and a backstepping nonlinear controller that we constructed for the tracked vehicles are compared with and without clutch wear. Maximum tracking error is decreased by 98% with proposed adaptive PID control structure with nonlinear feedforward term compare to backstepping controller. In the case of clutch wear, the back-stepping control exists in the literature has been found to result in oscillation. By updating the estimated friction coefficient from adaptation algorithm, in the backstepping controller, it is concluded that these oscillations can be eliminated. Additionally, on-off solenoid valves, are widely used, are known to cause torque interruptions and jerks during gear shifting. It has been observed the control structure presented in this study reduced the jerks by one quarter.

New type of overrunning clutch based on curved-plate compression-torsion metamaterial

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Simulation Research on the Drag Torque of Disengaged Wet Clutches

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Mathematical model and feature analysis of chain-ring overrunning clutch

Principle and Simulation Analysis of a Novel Structure Non-Contact Electromagnetic Clutch

Design and Modeling of an Electric Wedge Clutch

A non-contact electromagnetic clutch suitable for high rotating speed application

Design of a High Torque Density Single-Disc Electromagnetic Clutch

Research on the Soft-Starting Characteristics of Wet Clutches in TBM Cutter-Head Driving System.

Analysis of magnetorheological clutch with double cup-shaped gap excited by Halbach array based on finite element method and experiment

A Novel Telescoping Mechanism Integrating Spline Sliding and Worm Drive: an Energy-Saving and High-Efficient Solution for the Clutch of Mechanical Press

Development and evaluation of a magnetorheological fluid-based clutch with hybrid excitation

Simulation and Experiment of Viscous Torque for Disengaged Wet Clutches of Tracked Vehicle

Design, modeling, and analysis of wedge-based actuator with application to clutch-to-clutch shift

Structural Optimization of Clutch Activated by Magnetorheological Fluid

Design of a simplified detent clutch using curve arch spring for torque-overload protection

Linear magnetic clutch to automatically control torque output

Clutch Engagement Control Based on Stability Analysis

Design and testing of a novel two-way controllable overrunning clutch based magneto-rheological brake

Dynamic modeling, clutch parameter adaptation, and control of automatic transmission for tracked vehicles