Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Study of linearity of LYSO crystal for HERD calorimeter

Optical simulation of the non-uniformity for the LYSO crystal of the HERD calorimeter

Monte Carlo Simulation of HERD Calorimeter

Optimization of WLS fiber readout for the HERD calorimeter

Performance assessment of the HERD calorimeter with a photo-diode read-out system for high-energy electron beams

Beam test characterisation of a Plastic Scintillator Prototype for the space-based cosmic ray experiment HERD

The Silicon Charge Detector of the High Energy Cosmic Radiation Detection experiment

Latest advancements of the HERD space mission

Measurements of a LYSO crystal array from threshold to 100 MeV

Results on damage induced by high-energy protons in LYSO calorimeter crystals

Gamma-ray Performance of the High Energy Cosmic-Radiation Detection (HERD) Space Mission

Analysis and correction of crosstalk in the side-on transition radiation detector prototype for HERD

Design and Performance of a Low-Energy Gamma-Ray Trigger System for HERD

Design of a LYSO Crystal Electromagnetic Calorimeter for DarkSHINE Experiment

Design of High-speed readout electronics for the DarkSHINE electromagnetic calorimeter

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

Characterization of the energy response of a LYSO+SiPM detector module for E//B NPA using α and hydrogen ions

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

A Study of Sensitive Elements of CEPC-AHCAL

Beam Test Results of the RADiCAL -- a Radiation Hard Innovative EM Calorimeter