Abstract:Abstract In the widespread use of medical cyclotrons for isotope production, radiological and economic consequences related to the decommissioning of particle accelerators are often neglected. However, decommissioning regulation and its related procedures always demand efforts and costs that can unexpectedly impact on budgets. The magnitude of this impact depends strongly on the residual radioactivity of the accelerator and of the vault, and more specifically on the kind and activity concentration of residual radionuclides. This work reports and discusses a case study that analyzes in detail the characterization activities needed for optimized management of the decommissioning of a medical cyclotron vault. In particular, this paper presents the activities carried out for assessing the activity concentrations and for guiding the disposal of the cyclotron vault of the Italian National Cancer Institute of Milano (INT). An unshielded 17 MeV cyclotron vault was characterized by high resolution gamma-ray spectrometry both in-situ and in-laboratory on extracted samples. Monte Carlo simulations were also carried out to assess the overall distribution of activation in the vault. After a few months from the final shutdown of the accelerator, activity concentrations in the concrete walls due to neutron activation exceeded the clearance levels in many regions, especially close to the cyclotron target. Due to the relatively long half-lives of some radionuclides, a time interval of about 20 y after the end of bombardment is necessary for achieving clearance in some critical positions. Far from the target or in positions shielded by the cyclotron, activation levels were below the clearance level. The comparison between Monte Carlo simulations and experimental results shows a good agreement. The in-situ measurements, simpler and economically advantageous, cannot completely replace the destructive measurements, but they may limit the number of required samples and consequently the decommissioning costs. The methodology described and the results obtained demonstrated that it is possible to obtain accurate estimations of activity concentrations with cheap and quick in-situ measurements if the concentration profile in-depth inside the wall is well known. This profile can be obtained either experimentally or numerically through suitably validated Monte Carlo simulations.

Activation level of the concrete building and pressure vessel in JAEA-Tokai tandem accelerator

Measurements of neutron capture cross-sections for nuclides of interest in decommissioning: 45Sc, 63Cu, 64Zn, 109Ag, and 113In

Feasibility study of reactor radiation photon spectroscopy in Fugen for nuclear decommissioning

Evaluation of Gamma-Ray Dose Distribution in the Toroidal Direction of LHD Vacuum Vessel from Radionuclides Generated in Deuterium Plasma Experiments

Monitoring for Actinide Neutron Emissions From Spent Nuclear Fuel Under Extreme Gamma Fields Using Centrifugally Tensioned Metastable Fluid Detector Sensor Technology

Safety scenario and integrated thermofluid test

Development of scaling factors for the activated concrete of the KRR-2

Shielding Experiments Under JASMIN Collaboration at Fermilab(III) - Measurement of High-Energy Neutrons Penetrating a Thick Iron Shield from the Antiproton Production Target by AU Activation Method

Time-dependent variation of the neutron multiplication factor in spent fuel storage

ACTIVATION AND 3-DEMENSIONAL DOSE ANALYSIS SURROUNDING THE CONTROL RODS OF THE HTR-PM REACTOR WITH MONTE CARLO METHOD

Evaluating optimal quality assurance and quality control conditions of activation measurements at the accelerator-based boron neutron capture therapy system employing a lithium target

Assessment of radio-activation using spectroscopy in medical linear accelerators

Semi-Permanent Mass Production of Ac-225 for Cancer Therapy by the (3n,x) Reaction in Pressurized Water Reactor

Gamma and neutron detector performance in a MOX fuel fabrication plant environment

Cavity ionization chamber responses in the JAEA and the NMIJ high-energy photon reference fields for radiation protection

Evaluation of gamma dose rate for the ionization chamber tube in a reactor using the Monte Carlo method

Decommissioning for the Containment Vessel of HTR-PM: Monte Carlo Simulation and Long-Time Predictions

Activation Calculation and Radiation Analysis for China Fusion Engineering Test Reactor

JASMIN: Japanese-American study of muon interactions and neutron detection

Activation Analysis of the Reactor Pressure Vessel of Htr-Pm Reactor Using Fluka Code

Decommissioning of a Medical Cyclotron Vault: the Case Study of the National Cancer Institute of Milano