Abstract:With the increasing penetration level of renewable energy resources with less system inertia, accurate estimation of the power system inertia has become a critical issue for maintaining the frequency stability of the entire power system. To tackle out this challenging task, a two-stage data-driven method is proposed in this paper for estimating the system inertia from disturbed PMU measurements. First, by integrating its low-order system frequency response model with the first-order turbine model, analytical expressions of the frequency response under the steady-state and these transient oscillatory components are derived. Then, based on this parametric model, a two-stage estimation algorithm will be developed. At the first stage, system parameters of oscillatory components can be extracted from PMU measurements by Estimation of Signal Parameters via Rotational Invariance Techniques (ESPRIT). By utilizing frequency measurement data from PMUs and those estimated parameters from the ESPRIT algorithm, a weighted nonlinear least square approach is applied at the second stage to estimate physical parameters such as system inertia, damping coefficient, turbine time constant, and regulation coefficient. To validate the effectiveness of the proposed method, simulation studies of IEEE 39- bus system is investigated. Historical PMU measurements from various contingencies of Taiwan Power System will also be explored. All of these results demonstrated that the proposed method provides satisfactory performances with the mean relative error less than 10%. Comparisons with other existing methods are performed to demonstrate the advantage of the proposed method.

Power System Inertia Estimation Based on BJ Parameter Identification Method and PEM Iterative Algorithm

System Wide Parameter Identification of Multi-generators in Power Systems

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Improvements and measurements of parameter identification for electric load

Calculation for Minimum Inertia of Power System Based on Improved GWO Algorithm

Parameter Estimation of Synchronous Generator Based on Park Model

Online Transmission Line Impedance Parameter Identification for Distributed Generation

A Two-Stage Data-Driven Method for Estimating the System Inertia Utilizing Event-Driven PMU Measurements

Inertia Estimation of a Power System Area Based on Iterative Equation Error System Identification

Inertia Identification and Analysis for High-Power-Electronic-Penetrated Power System Based on Measurement Data

Comparative Study of Data-driven Area Inertia Estimation Approaches on WECC Power Systems

Dynamic Estimation of Power System Inertia Distribution Using Synchrophasor Measurements

Online Estimation of Power System Inertia Considering the Primary Frequency Control and Droop Control

Inertia Evaluation for Power System Based on Quasi-Steady-State Data

Virtual Inertia Control and Multi-time Scale Control Parameter Design of CHB-BESS

Estimation of Power Imbalance Size with Consideration of Impact of Emulated Inertia

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Inertia estimation of multi-area power systems using tie-line measurements and modal sensitivity analysis

Rotor Inertia Adaptive Control and Inertia Matching Strategy Based on Parallel Virtual Synchronous Generators System

Non-synchronous Inertia Estimation in a Renewable Energy Integrated Power System With Reduced Number of Monitoring Nodes

Generator Available Inertia Estimation Based on Various Disturbance Measurements of PMU