Abstract:The additional frequency control of wind turbines is an effective method to solve the problem of low inertia in power systems with high proportions of new energy. The primary frequency regulation of auxiliary wind power inertia systems based on rotor kinetic energy can not only make the wind turbine run at the maximum power point but also has the lowest cost and better economy of the auxiliary frequency regulation module. The wind power inertia output control scheme based on rotor kinetic energy control is constructed by considering the frequency response characteristics of synchronous generator sets and loads. The calculation model of the minimum inertia demand of the power system is established using the rate of change of frequency and the maximum frequency offset as constraints. Combined with the real-time operating conditions of the wind turbine, the speed regulation limit of the wind turbine rotor kinetic energy control is obtained to avoid wind turbine off-grid due to excessive frequency regulation. To prevent frequency secondary drop of the system during the speed recovery process, the steady speed recovery of the wind turbine is controlled by setting the rate of speed change. The feasibility of the strategy for the regulation of the auxiliary primary frequency proposed in this study was verified in an example based on a two-region, four-machine system. When a disturbance sets the sudden load power to 150 MW, under the kinetic energy control of the wind turbine rotor, the system frequency change rate and the maximum frequency offset are increased; in particular, the maximum frequency offset is reduced by 0.348 Hz, which further illustrates the flexibility and plasticity of the rotor kinetic energy control of the wind turbines. The results of this study provide a theoretical basis for adding additional frequency control to existing wind turbines.

Calculation for Minimum Inertia of Power System Based on Improved GWO Algorithm

Rolling Prediction Method of Input Wind Power of Wind Turbine Generators in Wind Farm

Common Mode Frequency Analysis Modeling and Quantification Method for Power System with High Penetration of Renewable Energy Generation

Adaptive Inertia VSG Control Method Involving Power and Power Change Rate

Optimal Allocation of Energy Storages: A Perspective of System Inertia Support

Critical Inertia Calculation Method of Generators Using Energy Balance Condition in Power System

An Aggregated Frequency Response Model for Power Systems with Renewables

Optimal Virtual Inertial-Based Power System Frequency Regulation Through Multi-Cluster Wind Turbines Using BWOA

Multi-Objective Adaptive Inertia and Droop Control Method of Wind Turbine Generators

Research on primary frequency regulation strategies for ancillary wind power inertia based on the rotor kinetic energy

Optimal Battery Storage Configuration for High-Proportion Renewable Power Systems Considering Minimum Inertia Requirements

Frequency Stability Enhancement of Low-Inertia Large-Scale Power System Based on Grey Wolf Optimization

Inertia Optimization Control and Transient Stability Analysis of Wind Power Grid-Connected System

Equivalent inertia prediction for power systems with virtual inertia based on PSO-SVM

Inertia Response of Power System Frequency Dynamics Based on The Quadratic Eigenvalue Approach

Virtual Inertial Control Strategy Based on Fuzzy Logic Algorithm for PMSG Wind Turbines to Enhance Frequency Stability

A New Algorithm of Oscillatory Active Power Increment Distribution in Low Frequency Oscillation Study

New design of a wind farm frequency control considering output uncertainty and fatigue suppression

Frequency Stability Enhancement of Microgrid Using Optimization Techniques-Based Adaptive Virtual Inertia Control

Research on Adaptive Virtual Inertia Compensation and Fast Frequency Response Strategy for New Energy Stations

Online estimation of inertia and frequency regulation capability based on small perturbation