Self‐Assembly of 0D–2D Heterostructure Electrocatalyst from MOF and MXene for Boosted Lithium Polysulfide Conversion Reaction

Zhengqing Ye,Ying Jiang,Li Li,Feng Wu,Renjie Chen

DOI: https://doi.org/10.1002/adma.202101204

IF: 29.4

2021-07-09

Advanced Materials

Abstract:<p>The design of nanostructured electrocatalysts with high activity and long-term durability for the sluggish lithium polysulfide (LiPS) conversion reaction is essential for the development of high-performance lithium–sulfur (Li–S) batteries. Here, the self-assembly of bimetallic selenides on nitrogen-doped MXene (CoZn-Se@N-MX) based on the self-assembly of metal–organic framework and MXene is reported. A combination of 0D CoZn-Se nanoparticles and 2D N-MX nanosheet co-catalysts forms double lithiophilic-sulfifilic binding sites that effectively immobilize and catalytically convert LiPS intermediates. This 0D–2D heterostructure catalyst has a hierarchical porous architecture with a large active area and enables rapid Li ion diffusion, reduces the activation energy of Li₂S deposition, and lowers the energy barrier of Li₂S dissolution. In addition, an assembled CoZn-Se@N-MX hybrid synergistically prevents the aggregation of the CoZn-Se nanoparticles and restacking of the active areas of N-MX nanosheets during assembly and the LiPS conversion process. The Li–S battery with this 0D–2D catalyst delivers excellent rate capability, ultralong cycling life (over 2000 cycles), and a high areal capacity of 6.6 mAh cm⁻² with a low electrolyte/sulfur ratio of 5 µL mg⁻¹.</p>

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper primarily addresses the key issues in lithium-sulfur batteries (Li-S batteries) — the slow conversion reaction of lithium polysulfides (LiPS) and the resulting shuttle effect. Lithium-sulfur batteries are considered promising candidates to replace traditional lithium-ion batteries due to their high theoretical capacity, environmental friendliness, and low cost. However, the solubility and insulating nature of lithium polysulfides during the charge-discharge process lead to severe shuttle effects, which not only cause the loss of active material sulfur but also exacerbate the corrosion of the lithium metal anode, thereby limiting the practical application of lithium-sulfur batteries.

To solve the above problems, researchers designed a self-assembled 0D-2D hybrid structure electrocatalyst (CoZn-Se@N-MX), which consists of selenides derived from metal-organic frameworks (MOF) and nitrogen-doped MXene. Specifically, this catalyst combines 0D CoZn-Se nanoparticles and 2D nitrogen-doped MXene nanosheets, forming dual lithium-philic and sulfur-philic binding sites that effectively immobilize and catalyze the conversion reaction of lithium polysulfides. Additionally, this 0D-2D hybrid structure has a hierarchical porous architecture that provides a large active surface area, facilitating the rapid diffusion of lithium ions and reducing the activation energy of Li2S deposition and the energy barrier of Li2S dissolution.

Experimental validation shows that this novel catalyst can significantly enhance the performance of lithium-sulfur batteries, including excellent rate capability and ultra-long cycle life (over 2000 cycles), as well as achieving a high areal capacity (6.6 mAh cm^-2) under a low electrolyte/sulfur ratio. These results indicate that CoZn-Se@N-MX as a sulfur electrocatalyst has great potential in next-generation high-performance lithium-sulfur batteries.