Abstract:In the absence of flux measurements, techniques of field orientations depend on motor parameters, particularly on rotor resistances. During operation in flux-oriented mode, online continuous estimation of harmonic and fundamental rotor resistances is important for multiphase IM. To limit the core saturation and to achieve the synchronous and aligned air-gap flux density distribution, the harmonic plane is based on magnetizing flux-oriented control (MFOC) whereas the fundamental plane is taken as rotor flux-oriented control (RFOC). Mismatch harmonic and fundamental resistances trigger deviations in the rotor and magnetizing flux and also cause misalignment in the resultant induced electromotive force (EMF) waveform which could, in turn, be the reason for over-excitation and under-excitation. This article formulates the simultaneous online identification of rotor resistances for particularly MFOC harmonic plane while the fundamental plane is RFOC based on the dot product of rotor flux and stator current for making a model reference adaptive system (MRAS). Mismatched stator resistance and dead time of inverter have a negligible effect on the reference model during steady state. Convergence and steady-state performance can be acquired for a variation of load conditions particularly at heavy loading. The validation of the proposed approach is verified through simulation and experiment results by incorporating a multiphase platform consisting of a seven-phase induction machine.

Corrections to " Validation of FEM-Based Parameter Estimation for Variable Phase-Pole Induction Machines"

A Novel Full Electrical Parameters Estimation Method of Permanent Magnet Linear Synchronous Machines Considering Parameter Asymmetry

Dynamic Regressor Extension and Mixing-Based Parameter Estimation for Permanent Magnet Linear Synchronous Machines Considering Parameter Asymmetry

Parameters Estimation for Multiphase Induction Machine with Concentrated Windings Through Finite Element Method

Multiplane Rotor Resistance Online Estimation Strategy for Multiphase Induction Machine under Nonsinusoidal Power Supply

Correction: Li, S. Et Al. Research on a Power Management System for Thermoelectric Generators to Drive Wireless Sensors on a Spindle Unit. Sensors 2014, 14, 12701–12714

Loss Investigation for Multiphase Induction Machine under Open-Circuit Fault Using Field–Circuit Coupling Finite Element Method

Slip Determination Considering Mismatched Fundamental and Harmonic Rotor Resistance for Multiphase Induction Machines under Non Sinusoidal Supply

Correction: de Menezes et al. A Thorough Procedure to Design Surface-Mounted Permanent Magnet Synchronous Generators. Machines 2024, 12, 384

Investigation of PMSM Back-EMF using Sensorless Control with Parameter Variations and Measurement Errors

Corrections to “Partial Discharge Investigation of Form-Wound Electric Machine Winding for Electric Aircraft Propulsion” [Mar 21 78-90]

Harmonic and Fundamental Rotor Resistance Estimation Scheme for Multiphase Induction Motor Based on Nonsinusoidal Supply Control

Strategies for the fault-tolerant current control of a multiphase machine under open phase conditions

Correction: Corrigendum: on the Speed of Piezostrain-Mediated Voltage-Driven Perpendicular Magnetization Reversal: a Computational Elastodynamics-Micromagnetic Phase-Field Study

Flux Weakening Control Of Interior Permanent Magnet Synchronous Machine To Improve Torque Performance

Prediction Error Analysis of Finite-Control-Set Model Predictive Current Control for IPMSMs

Calculation and Measurement of Parameters of A Multiphase Induction Motor

Study on the Improvement of the Correction Coefficient Considering the 3-D Effect of Spoke-Type Permanent-Magnet Synchronous Motor

Corrections to "An Improved Model of Voltage Source Converters for Power System Harmonic Studies"

Corrections to “predictive 3-D Modeling of Parasitic Gate Capacitance in Gate-all-Around Cylindrical Silicon Nanowire MOSFETs” [oct 11 3379-3387]

On-line parameter estimation for indirect field oriented control of induction machine based on steady state voltage model