Abstract:Ultrasonic inspection of coarse-grained steels is a common challenge in various industrial fields. This task is often difficult because of acoustic scattering that creates structural noise in the ultrasonic signals and images. Therefore, inspections usually use low-frequency probes, which achieve poor resolution with standard delay-and-sum (DAS) imaging techniques, such as the well-known total focusing method (TFM). The purpose of this paper is to evaluate the performance of a super-resolution ultrasonic imaging technique presented by Laroche et al. (IEEE Trans Comput Imaging 7:935–947, 2021) for the inspection of industrial coarse-grained materials. An image deconvolution problem (with spatially varying blur) is formulated, relying on a forward model that links the TFM image to the acoustic reflectivity map. The experiments consider an austenitic-ferritic stainless steel sample insonified using array probes at 3 MHz and 5 MHz placed in contact. The goal is to resolve two close reflectors corresponding to side-drilled holes (SDH) with diameter 0.4 mm spaced by 0.4 mm edge-to-edge and positioned at different depths (10, 20, 30, 40 mm). This configuration corresponds to a critical case where the distance between the two reflectors is much lower than the Rayleigh distance, that is the resolution limit of a DAS imaging system. These are typical cases where DAS images obtained from low-frequency inspections critically lack resolution, but where higher frequency probes cannot be used in practice, because a too week signal-to-noise ratio would affect the detection capability. As predicted by the Rayleigh criterion, TFM is not able to separate the reflectors. The proposed image reconstruction method successfully resolves the majority of the reflectors with a rather accurate distance estimation. In the context of coarse-grained structure inspection, subwavelength reflectors distant from each other by two times less than the resolution limit given by the Rayleigh criterion have been successfully detected and separated. This approach hence enables the use of low-frequency probes, in order to improve the signal-to-noise ratio, while keeping high resolution capability which can be particularly interesting for industrial applications. In particular, the proposed approach shows promising results for the sizing of a real crack in an industrial sample.

Towards flaw detection in welding joints via multi-frequency topological derivative methods

Detecting features of defect metal based on laser ultrasonic technique

Differential Two-Wave Mixing Interferometer for Crack Detection in Metallic Structures Based on Laser-Induced Ultrasound

A flaw echo detection method based on S-transformation and time-frequency spectrum spatial filtering

Characterization of welding defects by fractal analysis of ultrasonic signals

A New Insight on Phased Array Ultrasound Inspection in MIG/MAG Welding

A new methodology of Non-Destructive Testing in a set of two parallel immersed plates using time reversal process and Leaky Lamb waves

Use of the Plasma Spectrum RMS Signal for Arc-Welding Diagnostics

A Novel Defect Quantification Method Utilizing Multi-Sensor Magnetic Flux Leakage Signal Fusion

A Review of Non-Destructive Testing (NDT) Techniques for Defect Detection: Application to Fusion Welding and Future Wire Arc Additive Manufacturing Processes

A weld defects detection system based on a spectrometer

The Improvement of Flaw Detection by the Configuration of Uniform Eddy Current Probes

Exploring the performance of the topological energy method for object and damage detection from noisy and poor databases

Crack Detection for Welded Joint with Surface Coating Using Unsaturated AC Magnetic Flux Leakage

Application of advanced ultrasonic testing methods to Dissimilar Metal Welds -- Comparison of simulated and experimental results

Feasibility study of imaging spectroscopy to monitor the quality of online welding

Detection and Separation of Close Flaws in Coarse-Grained Materials Using Ultrasonic Image Deconvolution

Detection of defects in metallic specimens supported by ultrasound propagation simulations

An Acoustic Emission Activity Detection Method based on Short-Term Waveform Features: Application to Metallic Components under Uniaxial Tensile Test

Real Time Non-Destructive Testing Methods of Welding