Abstract:This paper presents the results of physical modelling of the process of multi-pass rolling of a wire rod with controlled, multi-stage cooling. The main goal of this study was to verify the possibility of using a torsion plastometer, which allows conducting tests on multi-sequence torsion, tensile, compression and in the so-called complex strain state to physically replicate the actual technological process. The advantage of the research methodology proposed in this paper in relation to work published so far, is its ability to replicate the entire deformation cycle while precisely preserving the temperature of the deformed material during individual stages of the reproduced technological process and its ability to quickly and accurately determine selected mechanical properties during a static tensile test. Changes in the most important parameters of the process (strain, strain rate, temperature, and yield stress) were analyzed for each variant. After physical modelling, the material was subjected to metallographic and hardness tests. Then, on the basis of mathematical models and using measurements of the average grain size, chemical composition, and hardness, the yield strength, ultimate tensile strength, and plasticity reserve were determined. The scope of the tests also included determining selected mechanical properties during a static tensile test. The obtained results were verified by comparing to results obtained under industrial conditions. The best variant was a variant consisting of physically replicating the rolling process in a bar rolling mill as multi-sequence non-free torsion; the rolling process in an NTM block (no twist mill) as non-free continuous torsion, with the total strain equal to the actual strain occurring at this stage of the technological process; and the rolling process in an RSM block (reducing and sizing mill) as tension, while maintaining the total strain value in this block. The differences between the most important mechanical parameters determined during a static tensile test of a wire rod under industrial conditions and the material after physical modelling were 1.5% for yield strength, approximately 6.1% for ultimate tensile strength, and approximately 4.1% for the relative reduction of the area in the fracture and plasticity reserve.

Modeling Reeling Process of Capillary Tubes Following Mandrel Drawing

Design and analysis of the mandrel structure for a composite S-shaped inlet

Consolidation and Warpage Deformation Finite Element Analysis of Filament Wound Tubes

Modeling of cold pilgering of stainless-steel tubes

Modelling of the Rolling Process of Titanium Alloy Tube Billets in Laboratory Conditions on a RSP 14-40 Rolling Mill

3D Rigid–plastic FEM Numerical Simulation on Tube Spinning

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

Study on the Influence of Mandrel Type on Copper Tube Rotary Draw Bending

Role of the Mandrel in the Variable Curvature Local-Induction-heating Bending Process of B1500HS Thin-Walled Rectangular Tubes

Finite-Elements Modeling and Simulation of Electrically-Assisted Rotary-Draw Bending Process for 6063 Aluminum Alloy Micro-Tube

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

Innovative Methodology for Physical Modelling of Multi-Pass Wire Rod Rolling with the Use of a Variable Strain Scheme

Failure Analysis and Design Modification of Mandrel in Chassis Tube Bending Machine

ANSYS Simulation of the Thermomechanical Behavior of a Large-Sized Composite Mandrel with Consideration of Viscoelasticity

Modeling and analysis of multi-pass progressive flanging force of copper tube end

Novel finite element model of analyzing wall thickness during tube drawing considering raw tube's thickness non-uniformity and die misalignment

FE Modeling of Warm Flanging Process of Large T-pipe from Thick-Wall Cylinder

A novelty mandrel supported thin-wall tube bending cross-section quality analysis: a diameter-adjustable multi-point contact mandrel

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes

A Comparison of Internal Mandrel Designs for Rotary Draw Bend Forming of Carbon-fibre/Thermoplastic (PA6) Tubular Structures

Stress State and Deformation Pattern During the Infeed Swaging of Tube Without Mandrel