Abstract:The Finite Element method was used to analyze the dynamic response of pile groups in the ground subjected to the liquefaction-induced lateral flow of soils.The u-p Finite Element for-mulation was used to depict the coupling effect of water and sand soil particles in the Finite Ele-ment analysis.A 3D numerical model was developed to analyze the effect of a 2×2 pile group sub-jected to liquefaction-induced lateral spreading.In this model,sand was simulated using a pres-sure-independent multi-yield surface plastic model.Clay material served as a nonlinear hysteretic material with a multi-surface kinematic plasticity model,and the pile group maintained its linear behavior in the process of calculation.The clay layer and saturated sand layer were meshed in a 20-node brick element and separately in a 20-8 node element.The boundary of the numerical model was considered as the shear beam boundary,which simulated the shear effect of the soil layer dur-ing the earthquake.Finally,the Rayleigh damping method was used to model the damping of the system.The dynamic response of each pile in pile group was compared,and it showed that the bending moment and displacement time history of piles at different depths developed in the same way,and the time of maximum bending moment and displacement of the pile appears to lag be-hind the time of peak acceleration of the input seismic wave.The maximum bending moment and displacement of the leading pile were larger than the those of the back piles.By comparing the maximum bending moment and displacement,it can also be concluded that,as depth increases,the maximum bending moment first increases and then decreases.The bending moment of the pile at the 2.5 m depth was greater than those at other depths.In terms of displacement,as depth in-creased,the maximum pile displacement decreased,and the maximum displacement of the pile head was greater than other observed points on the pile.This demonstrated the different behaviors of the pile bending moment response.In order to consider the effect of pile spacing on the pile group effect,several Finite Element models were developed for different pile spacing.This model-ing concluded that the maximum bending moment appeared to occur in the boundary of different soil layers.As pile spacing increased,the maximum bending moment and pile head displacement in the group increased.In the pile group with pile spacing equal to 7D (diameter),the maximum bending moment of the each pile was very close.The difference was about 3% when pile spacing was equal to 5D ,and the difference was about 4%,when pile spacing was equal to 3D .The maxi-mum bending moment of the first pile group was 10% larger than the bending moment of the sec-ond pile group.In the last part of the study,the cause of the pile group effect was analyzed and a basic understanding of the seismic design requirements for this type of pile group was obtained.

Study on seismic response difference of horizontal and inclined liquefied site-pile-structure

Influence analysis of overlying soil layer to seismic behavior of inclined liquefiable soil and pile interaction system

Seismic performance of pile group-structure system in liquefiable and non-liquefiable soil from large-scale shake table tests

Seismic response comparison and sensitivity analysis of pile foundation in liquefiable and non-liquefiable soils

Experimental Study on Seismic Instability of Pile-Supported Structure Considering Different Ground Conditions

Strong Seismic Response of Pile Group-soil Coupling System in Liquefied Ground

Analysis of the Bridge Pile Group Effect in Liquefaction-induced Lateral Spreading Sites

Effects of kinematic and inertial interaction on seismic responses of pile-structure system in liquefiable and non-liquefiable deposits

Analysis on Kinematic and Inertial Interaction in Liquefiable Soil-Pile-structure Dynamic System

Effects of different test methods on the seismic dynamic response in inclined liquefiable soil

Influence of the Soil Liquefaction on Dynamic Characteristics of a Base-Isolated Structure Investigated by the Experimental Method

Response of Soil–pile–superstructure–quay Wall System to Lateral Displacement under Horizontal and Vertical Earthquake Excitations

Dynamic Response Analysis of Pile Group Foundation of Super-Giant Sewage Treatment Structure on Hydraulic Fill Foundation

Numerical investigation of phase relationship between kinematic and inertial loads of piles behind a quay wall in liquefiable ground

Seismic Performance of Pile Groups under Liquefaction-Induced Lateral Spreading: Insights from Advanced Numerical Modeling

Influence of structure on the aseismic stability and dynamic responses of liquefiable soil

Numerical Analysis on Seismic Response and Failure Mechanism of Articulated Pile–structure System in a Liquefiable Site from Shaking-Table Experiments

Effect of ground motion characteristics on seismic response of pile foundations in liquefying soil

Liquefaction-induced settlement of the pile group under vertical and horizontal ground motions

Study on Vertical Load Distribution of Pile Group–Liquefied Soil System under Horizontal Seismic Environment

Large-scale shaking table test and three-dimensional numerical simulation research on earthquake seismic failure response of laterally spreading site-pile group-superstructure system