Abstract:<p>The performance of proton exchange membrane fuel cells (PEMFCs) varies greatly under different operating conditions. Reasonable combination of operating parameters can extend the life of fuel cells and promote the output efficiency. In this paper, a three-dimensional multi-component transport CFD model coupled with electrochemical calculation is developed for cell simulation, and then the sensitivity of PEMFCs performance to each parameter are analyzed. Firstly, to avoid a large number of parameter combinations and reduce computations, Box-Behnken design (BBD) is adopted for the arrangement of numerical cases. Then based on numerical simulation, current density and oxygen molarity distribution on the cathode film surface of each case are obtained. The fitted equations of current density and gas concentration to operating parameters are deduced through multiple quadratic regression equations, and then the optimal combination of parameters for current density is obtained on the basis of Response surface methodology (RSM). Subsequently, the sensitivities of each parameter under optimal condition to current density and internal gas molar concentration are calculated, respectively. The results show that the change in operating pressure has the most significant impact on both current density and gas distribution for PEMFCs and the next are the changes in temperature and relative humidity on both sides. Besides, the change of porosity will remarkably affect the uniformity of gas distribution. To further assess the applicability of PEMFCs sensitivity under different conditions, the sensitivities of each parameter at optimal condition are compared with that originates from wide range of conditions. It is found that there is not much difference between the sensitivity under the optimal condition and sensitivity deduced from the initial condition where each parameter has a wide range of scope, which confirms the generality of the sensitivity obtained under the specified conditions.</p>

Effect of Operating Conditions on Voltage Transient Response of High‐Temperature Proton Exchange Membrane Fuel Cell Under Load Changing

Effects of operating parameters and load mode on dynamic cell performance of proton exchange membrane fuel cell

Dynamic Response During PEM Fuel Cell Loading-up

Insight into the Mechanisms and In-Plane Reaction Heterogeneity of the Dynamic Response of Proton Exchange Membrane Fuel Cells

Experimental and Modeling Study on Water Dynamic Transport of the Proton Exchange Membrane Fuel Cell under Transient Air Flow and Load Change

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Dynamic Performance of a High-Temperature PEM Fuel Cell – an Experimental Study

A Study on Current Overshoot During Start-Ups and Optimal Start-Up Strategy of Proton Exchange Membrane Fuel Cells

Voltage Readjustment Methodology According to Pressure and Temperature Applied to a High Temperature PEM Fuel Cell

Reaction Gas Pressure, Temperature, and Membrane Water Content Modulate Electrochemical Process of a PEMFC: A Simulation Study

Experimental investigation of dynamic performance and transient responses of a kW-class PEM fuel cell stack under various load changes

Influencing Sensitivities of Critical Operating Parameters on PEMFC Output Performance and Gas Distribution Quality under Different Electrical Load Conditions

Sensitivity analysis of proton exchange membrane fuel cell performance to operating parameters and its applicability assessment under different conditions

Mechanistic investigation on the voltage collapse of polymer electrolyte membrane fuel cell under high-temperature and low-humidity conditions

Analysis of Proton Exchange Membrane Fuel Cell reactant gas dynamic response and distribution quality

Experimental investigation of time-dependent electrical load effects through multipoints in-situ measurement of temperature and relative humidity of PEMFC bipolar plate under transient operation

Operation Parameters of Air-Cooled Fuel Cell Based on In-Situ Testing of Reaction State

Dynamic Characteristics of Local Current Densities and Temperatures in Proton Exchange Membrane Fuel Cells During Reactant Starvations

Experimental Investigation of Reverse Voltage Phenomenon During Galvanostatic Start-Up of a Proton Exchange Membrane Fuel Cell

Investigation and analysis of proton exchange membrane fuel cell dynamic response characteristics on hydrogen consumption of fuel cell vehicle

Experiment on Ohmic Resistance of Proton Exchange Membrane Fuel Cell