Abstract:As one of the methods to harvest and then reuse the traffic-induced mechanical energy or one of the materials to make specific piezoelectric sensors, the application of piezoelectric ceramic to the traffic engineering has drawn more and more attention in recent years. However, few studies have tried to install the piezoelectric ceramic especially piezoelectric patch in the unbound granular materials (UGMs) of pavement base or subbase layers, and then to investigate their coupling including the power generation characteristics of piezoelectric ceramic and the resilient behavior of UGMs under traffic loading. In this study, a special piezoelectric transducer in which the piezoelectric ceramic worked in a single 31-mode was made and it was installed in the UGMs sample. A series of resilient deformation tests based on a large-scale triaxial apparatus was performed to explore the effects of water content of UGMs, confining pressure, cyclic stress magnitude and initial deviatoric stress on the open-circuit voltage generated by piezoelectric patch, and the influences of power generation on the resilient modulus of UGMs. Test results show that the open-circuit voltage in saturated sample is larger than that in sample of optimum moisture condition. The increase in both confining pressure and cyclic stress magnitude lead to the increase in open-circuit voltage, while the influence of initial deviatoric stress is slight. However, the development patterns of open-circuit voltage over either confining pressure or cyclic stress magnitude are very different between the two water content conditions. The power generation by piezoelectric ceramic tends to lower the resilient modulus of UGMs. In general, the installation of piezoelectric ceramic in the UGMs of base or subbase layers is feasible, which provides another way to harvest the traffic-induced mechanical energy. The cyclic stress level should be the key factor influencing the power generation of piezoelectric ceramic, while the confining pressure and water content of UGMs would play minor but non-negligible roles.

Correlation between electricity generation of piezoelectric ceramics and cyclic behavior of UGMs under traffic loading

Applicability Evaluation of a Two-Dimensional Piezoelectric Transducer to Monitor Dynamic Soil Stress in Unbound Granular Materials of Road Engineering

Experimental study on the road energy harvesting of piezoelectric ceramic in unbound granular materials based on a large-scale triaxial apparatus

Mechanical Energy Harvesting from Road Pavements under Vehicular Load Using Embedded Piezoelectric Elements

The Optimal Design of a Piezoelectric Energy Harvester for Smart Pavements

Piezoelectric Energy Harvesting from Roadways under Open-Traffic Conditions: Analysis and Optimization with Scaling Law Method

Theoretical Assessment on Piezoelectric Energy Harvesting in Smart Self-powered Asphalt Pavements

Piezoelectric Energy Harvesting from Roadway Deformation under Various Traffic Flow Conditions

Experimental study on dynamic characteristics of unbound granular materials under cyclic loading with different frequencies

Optimal Lateral Embedded Position of Piezoelectric Energy Harvesters under Various Traffic Conditions with Wheel-Path Distribution

Electric energy output model of a piezoelectric transducer for pavement application under vehicle load excitation

Numerical Analysis of Signal Response Characteristic of Piezoelectric Energy Harvesters Embedded in Pavement

Design and testing of road piezoelectric power generation device based on traffic environment applicability

Design of piezoelectric device compatible with pavement considering traffic: Simulation, laboratory and on-site

Development in Stacked-Array-Type Piezoelectric Energy Harvester in Asphalt Pavement

Preparation and Performance Study of a New Type of Tile Transducer for Roadway Applications

Influence of Grain Gradation on Permanent Strain of Unbound Granular Materials under Low Confining Pressure and High-Cycle Loading

Numerical Study on Influence of Piezoelectric Energy Harvester on Asphalt Pavement Structural Responses

Experimental Investigation of Piezoelectric Energy Harvesters Applied in Concrete Pavement

Coupled dynamic and piezoelectric response of RPEHs embedded in road under traffic load via multiscale finite element models

Real-time Monitoring for Road-Base Quality with the Aid of Buried Piezoelectric Sensors