Abstract:As one of the methods to harvest and then reuse the traffic-induced mechanical energy or one of the materials to make specific piezoelectric sensors, the application of piezoelectric ceramic to the traffic engineering has drawn more and more attention in recent years. However, few studies have tried to install the piezoelectric ceramic especially piezoelectric patch in the unbound granular materials (UGMs) of pavement base or subbase layers, and then to investigate their coupling including the power generation characteristics of piezoelectric ceramic and the resilient behavior of UGMs under traffic loading. In this study, a special piezoelectric transducer in which the piezoelectric ceramic worked in a single 31-mode was made and it was installed in the UGMs sample. A series of resilient deformation tests based on a large-scale triaxial apparatus was performed to explore the effects of water content of UGMs, confining pressure, cyclic stress magnitude and initial deviatoric stress on the open-circuit voltage generated by piezoelectric patch, and the influences of power generation on the resilient modulus of UGMs. Test results show that the open-circuit voltage in saturated sample is larger than that in sample of optimum moisture condition. The increase in both confining pressure and cyclic stress magnitude lead to the increase in open-circuit voltage, while the influence of initial deviatoric stress is slight. However, the development patterns of open-circuit voltage over either confining pressure or cyclic stress magnitude are very different between the two water content conditions. The power generation by piezoelectric ceramic tends to lower the resilient modulus of UGMs. In general, the installation of piezoelectric ceramic in the UGMs of base or subbase layers is feasible, which provides another way to harvest the traffic-induced mechanical energy. The cyclic stress level should be the key factor influencing the power generation of piezoelectric ceramic, while the confining pressure and water content of UGMs would play minor but non-negligible roles.

Preparation and Performance Study of a New Type of Tile Transducer for Roadway Applications

A High-Reliability Piezoelectric Tile Transducer for Converting Bridge Vibration to Electrical Energy for Smart Transportation

The Optimal Design of a Piezoelectric Energy Harvester for Smart Pavements

Applicability Evaluation of a Two-Dimensional Piezoelectric Transducer to Monitor Dynamic Soil Stress in Unbound Granular Materials of Road Engineering

An investigation of piezoelectric tile with drop test technique for energy harvesting application

Piezoelectric Energy Harvesting from Roadways under Open-Traffic Conditions: Analysis and Optimization with Scaling Law Method

Design and Fabrication of an Underwater Transducer Based on the Shear Vibration Mode and Trapezoid Transition Layer

Mechanical Energy Harvesting from Road Pavements under Vehicular Load Using Embedded Piezoelectric Elements

Electric energy output model of a piezoelectric transducer for pavement application under vehicle load excitation

3D Printed Piezoelectric Porous Structure with Enhanced Output Performance and Stress-electricity Response for Road Energy Harvesting

Piezoelectric Energy Harvesting from Roadway Deformation under Various Traffic Flow Conditions

Design and testing of road piezoelectric power generation device based on traffic environment applicability

Experimental study on the road energy harvesting of piezoelectric ceramic in unbound granular materials based on a large-scale triaxial apparatus

Theoretical Assessment on Piezoelectric Energy Harvesting in Smart Self-powered Asphalt Pavements

Development and Piezoelectric Properties of a Stack Units-Based Piezoelectric Device for Roadway Application

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Experimental Investigation of Piezoelectric Energy Harvesters Applied in Concrete Pavement

Response Surface Methodology Analysis of Energy Harvesting System over Pathway Tiles

Performance Assessment and Comparison of Two Piezoelectric Energy Harvesters Developed for Pavement Application: Case Study

Development and performance of a piezoelectric energy conversion structure applied in pavement

Design and analysis of a hollow triangular piezoelectric cantilever beam harvester for vibration energy collection