Abstract:The effect of hydrothermal conditions on the interactions between surfactant molecules and silicate species plays a key role in the structural transformations of silica precursors. In this work the structures of different siliceous products obtained at various synthesis temperatures have been characterized by powder X-ray diffraction (XRD), FT-IR spectroscopy, Al-27 and Si-29 magic angle spinning (MAS) NMR, N-2 adsorption/desorption measurements, and thermogravimetric analysis. The XRD) results show that the removal of other soluble ions from synthesis mixture is a primary step for preparation of the mesostructure in the CTAB-silicate-water synthesis system. Increasing the hydrothermal temperature may lead to the various structures of porous silica and change the behaviors of surfactants in the synthesis mixture. With the increase of hydrothermal temperature from 100 degrees C to above 165 degrees C or the prolonging of reaction time at a fixed temperature of 170 degrees C, the transformation sequence of the following structural phases is identified by XRD: hexagonal MCM-41 --> lamellar M41S --> ZSM-5. Comparison with the results from XRD, pore structure measurement, FT-W, and NMR demonstrates that the intermediate product from the hexagonal mesostructure to microporous crystallite is the lamellar phase rather than the ill-defined hexagonal structure. DTG results indicate that the formation of different structures could result from the different surfactant templating molecules. The main contribution of this work hes in attempts to provide an effective route for controlling conditions of the formation of different mesoporous phases and to understand the cooperation of surfactant molecules and inorganic species.

Research on the effects of hydrothermal synthesis conditions on the crystal habit of MIL-121

Insights into 1,2-Dihydroxybenzene Addition on Twin Suppression During the Secondary Hydrothermal Synthesis of B-Oriented MFI Zeolite Films

Effects of the synthesis hydrogel on the formation of zeolite LTA membranes

Control of crystallization rate and morphology of zeolite silicalite-1 in solvent-free synthesis

Influence of cations (Li+, Na+, K+)for synthesis mesoporous molecular sieve MCM-41 and their properties

Influences of Seeds on the Properties of Zeolite NaA Membranes on Alumina Hollow Fibers

Influences of anions X-(F-, Cl-, Br-) on synthesis and properties of mesoporous molecular sieve MCM -41

Influence of synthesis condition on magnesium hydroxide properties by two-step reaction on pilot scale

Effects of Recrystallization Parameters on the Formation of Hollow Silicalite-1 Zeolite

Effect of H2O/DMF Mixed Solvents on Formation of MIL-100(Fe) and Dye Adsorption

Influence of 1-methyl-3-octylimidazolium chloride on MIL-53(Al) crystallinity and particle size

Hydrothermal Transformation and Characterization of Porous Silica Templated by Surfactants

Experimental investigation on water vapor adsorption performance of solvent-free synthesized MIL-100(Fe) and its composite adsorbent

Regulation of hydrophobicity and water adsorption of MIL-101(Cr) through post-synthetic modification

Size- and Morphology-Controlled Nh2-Mil-53(Al) Prepared in Dmf-Water Mixed Solvents

Synthesis of high-crystallinity MIL-125 with outstanding xylene isomer separation performance

Effect of some factors on properties of ZSM-5 membrane during synthesis of zeolite membrane

Conventional Hydrothermal Synthesis of MFI Zeolite in Methanol Solution

High-Temperature Synthesis of Zeolite Y

Effect of Synthesis Conditions on the Structural and Catalytic Properties of Hierarchically Structured ZSM-5 Zeolites

Research on In-Situ Synthesis of ZSM-5 Molecular Sieve on Kaolin Microspheres by Crystal Seed Method