Autologous bone harvested during implant bed preparation: A randomized clinical trial comparing high‐speed drilling with irrigation versus low‐speed drilling without irrigation

Juan Carlos Bernabeu‐Mira,Miguel Peñarrocha‐Diago,Luigi Canullo,Fabio Camacho‐Alonso,Arthur Rodriguez Gonzalez Cortes,David Peñarrocha‐Oltra
DOI: https://doi.org/10.1111/cid.13346
2024-05-29
Clinical Implant Dentistry and Related Research
Abstract:Objective To compare collected bone weight and the frequency of autologous bone harvesting from the flutes of surgical drills used for implant bed preparation using two different drilling techniques. A comparative evaluation of radiographic bone density and bone quality was also made. Materials and Methods A randomized clinical trial was made of 66 dental implants in patients with a single posterior edentulous site. The compared drilling techniques were high‐speed drilling with irrigation (control group) and low‐speed drilling without irrigation (test group). The bone collected in both groups was dried and weighed with a precise electronic balance. The frequency of harvesting was calculated. The median radiographic bone density of each implant site was measured using cone‐beam computed tomography (CBCT) pixel values. Patient sex, age, implant position and dimensions, as well as the last drill diameter were analyzed as independent variables. The level of significance was 5%. Results The harvesting of bone chips from drill flutes proved possible in 51.5% of the procedures in the control group and in 100% in the test group (p
dentistry, oral surgery & medicine
What problem does this paper attempt to address?