Medium Bandgap Non‐fullerene Acceptor Enabling Organic Photovoltaic Cell with 30% Efficiency Under Indoor Artificial Light
Tao Zhang,Cunbin An,Ye Xu,Pengqing Bi,Zhihao Chen,Jingwen Wang,Ni Yang,Yi Yang,Bowei Xu,Huifeng Yao,Xiaotao Hao,Shaoqing Zhang,Jianhui Hou
DOI: https://doi.org/10.1002/adma.202207009
IF: 29.4
2022-09-14
Advanced Materials
Abstract:The correlation between molecular structure and photovoltaic performance is lagging for constructing high‐performance indoor organic photovoltaic (IOPV) cells. Herein, this relationship is investigated in depth by employing two medium bandgap non‐fullerene acceptors (NFAs). The newly synthesized NFA of FTCC‐Br exhibits a similar optical gap and molecular energy level, but a much stronger dipole moment and larger average electrostatic potential (ESP) compared with the ITCC. After blending with the polymer donor PB2, the PB2:ITCC and PB2:FTCC‐Br blends exhibit favorable bulk heterojunction (BHJ) morphologies and the same driving force, but the PB2:FTCC‐Br blend exhibits a large ESP difference. In organic photovoltaic (OPV) cells, the PB2:ITCC‐based device produces a decent power conversion efficiency (PCE) of 11.0%, whereas the PB2:FTCC‐Br‐based device gives a PCE of up to 14.8% with an open‐circuit voltage (VOC) of 1.05 V, which is the highest value among organic photovoltaic cells with VOCs above 1.0 V. When both acceptor‐based devices work under 1000 lux of 3000 K light‐emitting diode (LED), the PB2:ITCC‐based 1 cm2 device yields a good PCE of 25.4%; in contrast, the PB2:FTCC‐Br‐based 1 cm2 device outputs an outstanding PCE of 30.2%, which is the best PCE among IOPV cells. These results suggest that a large ESP offset in photovoltaic materials is important for achieving high‐efficiency OPV cells. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology