Abstract:As an alternative to monopiles, suction bucket jacket foundations are gaining increasing popularity in China for supporting offshore wind turbines. One of the major design challenges and governing factors for foundation sizing is the long-term tilt caused by the differential settlement between the buckets due to a combination of prevailing wind directions and soft seabed conditions. The assessment of the long-term consolidation settlement is complicated and subjected to uncertainties, such as the load sharing between the skirt and the bucket lid, and load re-distribution with time as the soil response transits from short-term undrained behaviour to long-term drained behaviour. This paper presents an attempt to understand the short-term and long-term load sharing mechanisms for the suction bucket foundation by means of finite element analysis. Without modelling the large deformation installation process explicitly, the initial (undrained) load sharing mechanism and induced additional stress (or excess pore water pressure) in the soil body is first examined. The re-distribution of the load between the skirts and the lid as the excess pore pressures dissipate is subsequently investigated. The study examines a range of soil conditions and foundation aspect ratios. It is found that the undrained skirt wall friction capacity relative to the load level has an important impact on the initial load sharing mechanism. As consolidation takes place, significant load redistribution occurs, with the loads carried initially by the lid partially or fully transferred to the internal and external skirt wall frictions. The load sharing at completion of consolidation heavily depends on the drained skirt friction capacity relative to the load level. Guided by the numerical findings, a tentative analytical model for practical design purpose is proposed.

Exploring the bearing characteristics of suction bucket foundations in Offshore wind turbines: A comprehensive analysis of tensile and compressive behavior

An Investigation into the Lateral Loading Response of Shallow Bucket Foundations for Offshore Wind Turbines Through Centrifuge Modeling in Sand

Analysis and Design of Bearing Capacity of Suction Caisson Foundations of Offshore Wind Turbines

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Analysis of Bearing Performance of Monopile and Single Suction Bucket Foundation for Offshore Wind Power under Horizontal Load

Numerical Simulation of Offshore Suction Bucket Foundation Pullout Characteristics under Undrained Conditions

Comparison of Monotonic and Cyclic Lateral Response Between Monopod and Tripod Bucket Foundations in Medium Dense Sand

Study on frequency domain impedance of wide-shallow composite bucket foundation for offshore wind turbine

Upper Bound Solution of the Resisting Moment Bearing Capacity of A Composite Bucket Shallow Foundation of An Offshore Wind Turbine in Sand

Sensitivity Analysis of Factors Affecting the Bearing Capacity of Suction Bucket Foundation in Soft Clay

On Load-Bearing and Soil-Reacting Characteristics of Hybrid Pile-Bucket Foundations Subjected to Static Horizontal Loading

Numerical analysis of the effect of multidirectional load on the bearing capacity of suction bucket foundation

Undrained Capacity of a Bucket Foundation with a Limited-Tension Interface for Offshore Wind Turbines

Field test on the mechanism of composite bucket foundation penetrating sandy silt overlying clay

Horizontal Bearing Performance of the Four-Bucket Jacket Foundation

Long-term settlement of suction bucket foundations supporting offshore wind turbines in clay

Centrifuge tests exploring the cyclic performance of suction bucket foundations in cohesionless soils

Seismic response of the composite bucket foundation supported offshore wind turbines under marine environmental loadings

Experimental Investigation on the Motion Characteristics of Air-Floating Tripod Bucket Foundation during Free Floating

Centrifuge and Numerical Simulation of Offshore Wind Turbine Suction Bucket Foundation Seismic Response in Inclined Liquefiable Ground

Design method of geotechnical capacity for tripod suction bucket foundations in clay